Front Panel Controls - Harman Kardon AVR 120 Owner's Manual

Front Panel Controls

30
Main Power Switch
System Power Control
Power Indicator
Headphone Jack
Selector Buttons
Tone Mode
Surround Mode Selector
Tuning Selector
Tuner Band Selector
Preset Stations Selector
Main Power Switch: Press this button to
apply power to the AVR 120. When the switch
is pressed in, the unit is placed in a Standby
mode, as indicated by the amber LED
rounding the System Power Control
This button MUST be pressed in to operate the
unit. To turn the unit off and prevent the use
of the remote control, this switch should be
pressed until it pops out from the front panel
so that the word "OFF" may be read at the
top of the switch.
NOTE: This switch is normally left in the "ON"
position.
System Power Control: When the Main
Power Switch is "ON, " press this button
to turn on the AVR 120; press it again to turn
the unit off. Note that the Power Indicator
surrounding the switch will turn green
when the unit is on.
29
AVR 120
Input Source Selector
FM Mode Selector
Digital Optical 3 Input
Digital Coax 3 Input
Video 4 Video Input Jacks
Video 4 Audio Input Jacks
Bass Control
Balance Control
Treble Control
Volume Control
Power Indicator: This LED will be illumi-
nated in amber when the unit is in the Standby
mode to signal that the unit is ready to be
sur- turned on. When the unit is in operation, the
. indicator will turn green. Should the indicator
turn red, turn the unit off using the Main
Power Switch
connections to make certain that there are no
short circuits.
Headphone Jack: This jack may be used to
listen to the AVR 120's output through a pair of
headphones. Be certain that the headphones
have a standard 1 / " stereo phone plug. Note
4
that the main room speakers will automatically
be turned off when the headphone jack is in use.
Selector Buttons: When you are establish-
ing the AVR 120's configuration settings, use
these buttons to select from the choices available,
as shown in the Main Information Display
or disables the Bass and Treble tone controls.
When the button is pressed so that the words
TONE IN appear in the Main Information
Display
Treble
and check the speaker wire output signals. When the button is pressed so
that the words TONE OUT appear in the Main
Information Display
will be "flat, " without any bass or treble alter-
ation, no matter how the actual Bass and
Treble Controls
ton to change the surround mode by scrolling
through the list of available modes. Note that
depending on the type of input, some modes
are not always available. (See page 22 for more
information about surround modes.)
.
Set Button
Input Indicators
Delay
Digital Input Selector
Main Information Display
Channel Select Button
Speaker Select Button
Test Tone Selector
Surround Mode Indicators
Remote Sensor Window
Tone Mode: Pressing this button enables
, the settings of the Bass
controls may be used to adjust the
, the output signal
are adjusted.
Surround Mode Selector: Press this but-
5 FRONT PANEL CONTROLS
and