Harman Kardon AVR 110 Owner's Manual page 20

System Configuration
To set the delay times, follow these steps:
1. Put the AVR 110 in the Dolby Pro Logic
mode by pressing the Surround Mode
Selector 7 on the front panel or by
pressing the Surround Mode Selector
j on the remote, until PRO LOGIC
appears in the Main Information Display
W and the PRO LOGIC indicator F
lights up.
29
2. Press the Delay button Ò
the remote or front panel. The words
S DELAY TIME will appear in the
Main Information Display W.
3. Press the Set button o
Ô .
4. Adjust the delay time by pressing the
buttons mq on the remote or the
⁄ / ¤
Selector buttons 5 on the front panel
until the delay time figure calculated using
the formula entered above appears in the
display.
5. If only analog sources will be used, no
adjustment is needed for the center-channel
delay. In that case, press the Set button
o
Ô to enter the surround delay settings
into the AVR 110's memory. However, if you
will be using digital sources and the calcu-
lations outlined above indicate that the
center-channel delay requires an adjust-
ment, continue with the following steps.
6. Before setting the center-channel delay
time, make certain that a digital source has
been selected. If a digital source is playing,
COAXIAL E or OPTICAL B will appear
in the Information Display Û
tal source is already connected and play-
ing, press the Delay button Ò
then the buttons on the remote
⁄ / ¤
mq or the front panel Selector
buttons 5 until the words C DELAY
TIME appear in the Main Information
Display and proceed to Step 10. If a
Û
digital source is not playing, follow Steps 7
through 10.
20 SYSTEM CONFIGURATION
7. Press the Set button o
8. Select the Dolby Digital mode either by
pressing the front panel Surround Mode
Selector 7 or by pressing the Surround
Mode Selector j on the remote on the
remote until DOLBY DIG appears in the
Main Information Display W.
9. Press the Delay button
the remote or front panel. The words
on S DELAY TIME appear in the
Main Information Display W.
10. Press the
⁄ / ¤
remote once, so that C DELAY TIME
appears in the Main Information Display
W or in the on-screen display.
11. Press the Set button o
12. Press the
⁄ /
remote or the Selector buttons 5 on
the front panel until the desired delay
time for the center channel appears in the
display.
13. Press the Set button o
setting into the AVR 110's memory.
You have now completed the setup, adjustment
and calibration of the AVR 110. You are now
ready to enjoy the finest in music and home-
theater listening.
. If a digi-
29 and
.
Ô
29 Ò on
buttons mq on the
Ô .
buttons mq on the
¤
Ô to enter the