Mitsubishi Electric Mr. Slim MS09TW Service Manual page 46

OPERATING PROCEDURE
3. Removing the electrical box
(1) Remove the front panel. (Refer to 1)
(2) Remove the electrical cover.
(3) Disconnect the connector of the indoor coil thermistor
(CN112).
(4) Disconnect the motor connector and the vane motor con-
nector (CN151) on the electronic control P.C. board.
(5) Remove the screw of the electrical box, remove the electri-
cal box.
4. Removing the vane motor
(1) Remove the front panel. (Refer to 1)
(2) Remove the electrical box. (Refer to 3)
(3) Pull out the drain hose from the nozzle assembly, remove
the nozzle assembly.
(4) Remove the screws (both upper and lower) of the vane
motor, disconnect the connector.
(5) Remove the vane motor.
5. Removing the indoor fan motor and the line flow fan
(1) Remove the front panel.
(2) Remove the electrical box.
(3) Unhook the catches on the both sides of the nozzle
assembly.
(4) Remove the nozzle assembly.
(5) Remove the screws of the bearing support.
(6) Remove the screw of the heat exchanger and unhook the
catch.
(7) Lifting the heat exchanger, remove the bearing support.
(8) Loose the screw fixing the line flow fan, remove the line flow
fan.
(9) Remove the screws of the motor band, remove the fan
motor.
Photo 3
Photo 4
Catch
Heat exchanger
screw
Screws of the
bearing support
Photo 5
Line flow fan
OB274-46
PHOTOS
Screw of the
Vane motor
electrical cover
Heat exchanger
Indoor fan motor
Screws of the
motor band
Screws
of the
vane
motor
Screws
of the
motor
band