Sony ST-RV555ES Operating Instructions Manual page 12

Other Hookups
S-LINK CONTROL S hookup
(Models of area code UC only)
If you have a S-LINK CONTROL S-compatible Sony TV,
satellite tuner, monitor, DVD player or VCR, use an
audio/video/control S connecting cord (supplied) or a
control S connecting cord (supplied) to connect the CTRL
S (STATUS) IN (for TV, satellite tuner, or monitor) or OUT
(for VCR, etc.) jack on the receiver to the appropriate S-
LINK jack on the respective component. Refer to the
operating instructions supplied with your TV, satellite
tuner, monitor, VCR, etc., for details.
The following illustration is an example of S-LINK
CONTROL S hookups between the receiver, a TV, a VCR,
and a DVD player. When your TV is connected to the
receiver as shown below, the TV input mode will change
to video input whenever you turn on the receiver. When
you connect the receiver as shown below, input mode of
the receiver changes to VIDEO 1 or DVD/LD whenever
you play your VCR or DVD.
The following connections also change the input mode of
the receiver to TV whenever you operate your TV.
TV
D
AUDIO
OUT
B
C
Receiver
*
TV/SAT DVD/LD
S VIDEO S VIDEO
IN IN
F F
VIDEO VIDEO
IN IN
CTRL S CTRL S
STATUS IN OUT
AUDIO AUDIO
IN IN
VCR 1
*
DVD
OUTPUT
player
VIDEO
OUT
S-LINK
IN
AUDIO
OUT
12
S-LINK
IN OUT
E
VIDEO
IN
A
* **
VIDEO 1
MONITOR
S VIDEO S VIDEO
OUT IN OUT
F F F
VIDEO VIDEO
OUT IN OUT
CTRL S CTRL S
OUT IN
AUDIO
*
OUTPUT S-LINK
IN
VIDEO
OUT
AUDIO
OUT
* Audio/video/control S connecting cord (Pull the video cord away
from the supplied audio/video/control S cable for connection A.)
** Control S connecting cord
Note
Refer to the instructions supplied with your TV for details
regarding the operations you can control from your TV.
CONTROL A1 hookup
• If you have a CONTROL A1
CD player, tape deck, or MD deck
Use a CONTROL A1 cord (not supplied) to connect the
CONTROL A1 jack on the CD player, tape deck, or
MD deck to the CONTROL A1
Refer to "CONTROL A1 Control System" on page 57
and the operating instructions supplied with your CD
player, tape deck, or MD deck for details.
Note
If you make CONTROL A1
an MD deck that is also connected to a computer, do not
operate the receiver while using the "Sony MD Editor"
software. This may cause a malfunction.
• If you have a Sony CD changer with a
COMMAND MODE selector
If your CD changer's COMMAND MODE selector can
be set to CD 1, CD 2, or CD 3, be sure to set the
command mode to "CD 1" and connect the changer to
the CD jacks on the receiver.
If, however, you have a Sony CD changer with VIDEO
OUT jacks, set the command mode to "CD 2" and
connect the changer to the VIDEO 2 jacks on the
receiver.
COMPONENT VIDEO hookup
If you have a TV, satellite tuner, DVD player, or LD player
with COMPONENT VIDEO (Y, B-Y, R-Y) output jacks and
a monitor with COMPONENT VIDEO input jacks, use a
video cord (not supplied) to connect to the receiver.
Connect a
TV or satellite tuner
DVD or LD player
Monitor
Notes
• If you make COMPONENT VIDEO connections, nothing is
displayed on the on-screen display.
• On this receiver, the component video signals are not
compatible with S-video signals nor video signals.
compatible Sony
jack on the receiver.
connections from the receiver to
To the
COMPONENT VIDEO TV/SAT
IN jacks
COMPONENT VIDEO DVD/LD
IN jacks
COMPONENT VIDEO
MONITOR OUT jacks