Smeg K143X Installation, Use And Maintenance Manual

Installation, Use
Maintenance Manual
OVEN HOOD K143X
Introduction
Dear Customer, we hereby thank you for choosing our Oven Hood
and hope you will be satisfied with our product.
1. Instructions
The following instruction manual is an integral part of the equipment
and must be at the operators' disposal for advice until the end of the life
cycle of the product.
Before carrying out any operations, carefully read the information
contained in the manual about safe installation, use and maintenance.
The equipment is only intended for the use it has been designed for,
by qualified and skilled personnel.
Installation, maintenance and repair operations must only be carried
out by an authorized technical service centre or qualified personnel, in
compliance with the regulations in force and according to the instructions
provided by the manufacturer.
When using it for the first time, make sure that the hood conveyor
connected to the exhaust ducts of the oven is positioned correctly, to
prevent vapour leakage. It is recommended to make sure that the
connection between the ducts and the oven is well sealed every time the
hood or the oven on which it is installed are moved.
The equipment must be earthed in accordance with the safety
regulations of the electrical system.
Page 1 of 3
The plug to be connected to the power cable must be compliant with
and
the regulations in force.
Do not block the openings, the heat ventilation and exhaust slits.
Use the hood at an ambient temperature between +5 °C and +35 °C.
This appliance is intended for professional use and complies with the
EC directives in force. The appliance functions must be considered as a
oven hood, therefore any other use of the device is improper.
The Manufacturer refuses all responsibility for direct and indirect
damage caused by improper installation, tampering with, inadequate
maintenance, improper use and failure to comply with the regulations
contained in the instruction manual.
2. Installation
All the materials, with the exception of silicone, used for installation
must resist a temperature of 150 °C without generating strains and/or
surface defects.
2.1 - Positioning
The Oven Hood must be positioned on the oven, after must be
fixed the conveyor by screws , that will be fixed to the rear oven's back
(Fig. 1).
Conveyor
Figure 1
2.2 - Electrical connection
The electrical connection, single phase 220 – 230 V ~ 50Hz, must
be carried out by qualified personnel in compliance with the European
regulations in force.
The Oven hood is supplied with electric cable and plug. If the plug
is replaced, it must be compatible with the maximum power of the hood.
It is recommended to have the installation done by a qualified electrician,
in compliance with the regulations in force.
Attention!!! – A bipolar safety switch must be set upstream of the hood.
Attention!!! – The equipment must be earthed properly according to the
safety regulations of the electrical system.