Subscribe to Our Youtube Channel
Related Manuals for Montiss MISTRAL CVC5783MW
Summary of Contents for Montiss MISTRAL CVC5783MW
- Page 1 User manual CORDLESS WET & DRY VACUUM CLEANER MISTRAL CVC5783MW 02/12 HOME APPLIANCES...
- Page 2 ...
-
Page 3: Table Of Contents
TABLE OF CONTENTS SAFETY REGULATIONS 4 THE PRODUCT 5 ASSEMBLY 6 THE USE ... -
Page 4: Safety Regulations
SAFETY REGULATIONS Warning: When using any electrical appliance, always observe all basic safety precautions. The following instructions should be followed to reduce the risk of fire, electric shock or injury. General: 1. Read this manual carefully before using the appliance. Keep this manual in a safe place for future reference. 2. Use the appliance only as described in this manual. 3. Make sure the power supply indicated on the charger corresponds with the local voltage before connecting the charger. 4. The charger should be plugged into a grounded electrical outlet. 5. Check the device regularly for damage. Do not use the device if the power cord or plug is damaged, or when any component of the device has been dropped or damaged. If the power cord is damaged, you must have it replaced by Home‐tek Europe Limited, a service centre authorized by Home‐tek Europe Limited or a similarly qualified person in order to avoid safety hazards. 6. This appliance is not suitable for use by children or persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless someone who is responsible for their safety is supervising them or explains to them how the appliance must be used. Close supervision is required if the appliance is used in the vicinity of children, pets or plants. 7. Never allow children to play with the packaging, there is a risk of suffocation. 8. Never leave the device unattended. Always switch the device off when cleaning or servicing the device or when not in use. 9. Keep the appliance and the charger away from flames and hot surfaces. 10. Store the appliance indoors. 11. ... -
Page 5: The Product
THE PRODUCT 1. Charger 16. Crevice nozzle 2. Bolt 17. Turbo brush 3. Nut 18. Main unit 4. Air inlet ... -
Page 6: Assembly
ASSEMBLY • Remove all packaging materials. • Clean the device with a wet cloth and some detergent if necessary (also see the paragraph "maintenance and cleaning"). • Make sure that all parts are clean and dry before assembling the appliance. 1. Place the nut into the hole at the top of the main unit (Pic. 1). 2. Attach the handle to the main unit (Pic. 2). 3. Place the bolt at the backside in the handle and turn the bolt clockwise to tighten it (Pic. 3). 4. Push the lock button turbo brush (28) while you place the main unit on the turbo brush (17) (Pic. 4). 5. Place the plastic cover filter (12) in the dust container (13). 6. Then put the HEPA‐filter (11) in the plastic cover filter. 7. Mount the dust container with HEPA‐filter thereafter on the motor (8). The hand vacuum cleaner is now fully assembled. 8. Push the hand vacuum cleaner next, with the front side downwards, into the main unit until you hear a click (Pic. 5). ... - Page 7 1. Make sure that the handheld vacuum cleaner has been mounted in the correct way (see chapter Assembly). 2. Turn on the handheld vacuum cleaner by pushing the on/off switch on the handle (7) forward (Pic. 7). 3. If desired, you can use the following attachments: Note: always turn off the handheld vacuum cleaner before you mount the attachments on it. a. Crevice nozzle (16) (Pic. 8) to clean corners, cracks and other places which are difficult to reach. b. Oval brush (15) (Pic. 9) to clean furniture. c. Rubber nozzle (14) (Pic. 10) to clean up liquids. Use of the upright vacuum cleaner Note: the upright vacuum cleaner can only be used to vacuum dry dirt. In order to vacuum wet dirt, you must use the handheld vacuum cleaner with the rubber nozzle. 1. Make sure that the upright vacuum cleaner has been mounted correctly (see chapter Assembly). 2. Turn on the upright vacuum cleaner by pushing the on/off switch on the handle (20) forward (Pic. 11). Charging As soon as the indication light power (6) is continuously on, you must recharge the device. Note: always turn off the device before recharging. At the moment you turn off the device, the power indication light will be switched off. As soon as the device has been fully recharged, the light will switch on again. After use Recharge the device after use so it will have full power the next time you use it. ...
-
Page 8: Maintenance And Cleaning
MAINTENANCE AND CLEANING Empty dust container Note: clean the dust container, the plastic cover and the HEPA‐filter regularly. The power decreases when the dust container is too full or when the HEPA‐filter is dirty. 1. Push the button (5) to unlock the dust container (Pic. 12). 2. Remove the HEPA‐filter (11) and the plastic cover (12) (Pic. 13). 3. Carefully shake the dust container (13), the plastic cover (12) and the HEPA‐filter (11) over a dust bin (Pic. 14 and 15). 4. The dust container (13), plastic cover (12) and the HEPA‐filter may be cleaned with water (Pic. 16). Note: do not use cleaning aids to clean the HEPA‐filter and make sure all parts are completely dry before you mount them back on and use the device. Cleaning the turbo brush 1. Push the button on the cover of the roller (30) downwards (Pic. 17). 2. Remove the roller (26) from the device (Fig. 18). 3. Remove the groove debris from the roller carefully, perhaps with scissors or a comb (Pic. 19). 5. The roller may be cleaned with water (Pic. 20). Note: make sure that the roller is completely dry before you mount it back on and use the device. 6. Mount the roller back onto the device (Pic. 21). 7. Put the cover of the roller back on its place and push the button up to lock it (Pic. 22). ... -
Page 9: Solving Problems
Cleaning the device Note: never immerse the device and/or the charger in water or other liquids. 1. Shut the device down before cleaning it. 2. Clean the device with a wet cloth and some detergent if necessary and dry off thoroughly. 3. Never use abrasives, bleaching agents or steel wool to clean the device. This could cause damage to the material. Storage Make sure that the device and the attachments are completely clean and dry before you store the device. SOLVING PROBLEMS Problem Possible cause Possible solution The device won't turn on Battery is empty Recharge the device The dust container is full Empty the dust container Low suction The HEPA‐filter is dirty Clean the HEPA‐filter The device has not been Recharge the device Battery empties faster recharged long enough The battery won't charge Replace the battery ... -
Page 10: Compulsory Information Regarding The Decree On Batteries
Batteries that need to be labelled by law are provided with one of the illustrations below, being a crossed‐out wheeled bin and the chemical symbol for the classification of pollutants‐containing heavy metals. The chemical symbol (Cd, Hg or Pb) will be shown under the illustration. The following text can be found on the pollutants‐containing batteries: Pb: Battery contains lead Cd: Battery contains cadmium Hg: Battery contains mercury TECHNICAL DETAILS Model number CVC5783MW Vacuum cleaner input 12V dc 100W Adapter input 230‐240V~50Hz, 40mA Adapter output 15V dc 200mA Montiss is a registered brand name of: Van den Berg Products BV IJzerwerf 10‐12 6641 TK Beuningen Netherlands www.vdbergproducts.com ... -
Page 11: Guarantee
GUARANTEE This guarantee covers your device for a period of 24 months from the date of purchase for service and replacement of parts, on the condition that you have used the device correctly as described in this user manual. This guarantee does not exclude national legislation that may exist in the country of purchase in regards to warranty regulations. When you make a claim under this guarantee, you must submit the original invoice or receipt with clear mention of the date of purchase, name of retailer and the description and model number of the device. You are advised to keep these documents in a safe place. This device is intended for domestic use only. Damage and/or malfunctions as the result of industrial or commercial use are excluded from the warranty. The guarantee does not cover the supplied accessories or other parts of the device that are subject to wear. If you want to reorder these parts, then that is possible through www.muppa.nl. The guarantee for this device expires if: • The original invoice or receipt has in one way or another been changed or made illegible; • The model or serial number on the device has been changed, removed, deleted or made illegible; • Repairs have been executed by unauthorized repair workshops or persons who are not authorized to do so; • The damage is the result of an external cause, such as fire damage, water damage, transport damage, atmospheric discharges, insufficient or improper maintenance; • The device has been operated in another country than for which originally designed, approved, released and produced, as well as defects occurred as the result of such modifications; • The device has not been used according to the guidelines and directions in this user manual supplied with the device. In the unlikely event your device is not functioning well or shows any defect, please contact your retailer. To avoid any inconvenience, we advise you to read this user manual carefully before ... -
Page 12: Service Form
SERVICE FORM Unfortunately we CANNOT handle any service forms that have been completed unclearly or partly. Therefore please always fill in the service form as clearly and completely as possible! THE PRODUCT Article number: CVC5783MW Article description: Montiss Cordless Wet & Dry Vacuum Cleaner Mistral Shop of purchase:..........................…… Date of purchase:.......................... YOUR DATA Name:.............................. Address:............................… Postal code:............................ City:.............................. Telephone:............................ Fax:.............................. E‐mail:.............................. DESCRIPTION OF THE PROBLEM ................................ ................................ ................................ ................................ ................................ ................................ You can send this form, together with the proof of purchase, to: Home‐tek Europe Limited Roe Head House, Far Common Road Mirfield, West Yorkshire England WF14 0DQ Tel: 08452 100888 Email: sales@hometek.co.uk ...
Need help?
Do you have a question about the MISTRAL CVC5783MW and is the answer not in the manual?
Questions and answers