Clear Space; Decorative Doors And Fronts; Remote Controls, Wall Controls And Wall Switches; Outside Air (Optional) - Heatilator BCBV36 Owner's Manual

C. Clear Space
WARNING! DO NOT place combustible objects in
front of the fireplace or block louvers. High tempera-
tures may start a fire. See Figure 2.2.
Avoid placing candles and other heat-sensitive objects on
mantel or hearth. Heat may damage these objects.
Clear space 3 ft (914 mm)
in front of appliance
Figure 2.2

Clear Space

D. Decorative Doors and Fronts
WARNING! Risk of Fire! Install ONLY doors or fronts
approved by Hearth & Home Technologies. Unapproved
doors or fronts may cause fireplace to overheat.
For more information refer to the instructions supplied
with your decorative door or front.
E. Remote Controls, Wall Controls and Wall
Switches
Follow the instructions supplied with the control installed
to operate your fireplace:
For safety:
• Install a switch lock or a wall/remote control with child
protection lockout feature.
• Keep remote controls out of reach of children.
See your dealer if you have questions.
8
F. Outside Air (optional)
The outside air kit supplies some fresh combustion air for
your fireplace. It may help reduce the effects of negative
air pressure. (See Section 9.A.)
•
•
CAUTION! Risk of Burns! The outside air control handle
is HOT when fireplace is in operation. Adjust BEFORE
lighting fire.
G. Before Lighting Fireplace
Before operating this fireplace for the first time, have a
qualified service technician:
•
•
•
•
•
•
Heatilator • BCBV36 • 4008-033 • Rev P • 8/12
Refer to Figure 2.1 for location of control.
Close the inlet to prevent cold drafts when the fireplace
is not being used.
Verify all shipping materials have been removed from
inside and/or underneath the firebox.
Review proper placement of logs, ember material and/or
other decorative materials.
Check the wiring.
Check the air shutter adjustment.
Ensure that there are no gas leaks.
Determine if this fireplace has a standing pilot or an
Intellifire ignition system. Ask your dealer or open control
access panel, look at gas valve assembly.
- A standing pilot ignition will have a red or black ignitor
button (refer to Figure 12.1).
- An Intellifire ignition system will not have a button.
Red Button
Figure 2.3 Ignitor Button