Siemens Hob Operating Instructions Manual page 20

`~êÉ çÑ íÜÉ ~ééäá~åÅÉ
cáñáåÖ ã~äÑìåÅíáçåë
Display
Malfunction
none The electric power supply
has been interrupted.
The appliance has not
been correctly connected
according to the
connection drawing.
Electronic system
malfunction
E flashes
The control panel is damp
or an object is resting
on it.
EÖ +
Electronic system
number malfunction
F2
The electronic system has
overheated and the
corresponding hotplate
has been switched off.
F4
The electronic system has
overheated and all the
hotplates have been
switched off.
Do not rest hot pans on the control panel.
F8
The hotplate has been on
for too long and has
switched off.
20
^ééäó ~å ~ÇÇáíáîÉ Ñçê íÜÉ éêçíÉÅíáçå ~åÇ éêÉëÉêî~íáçå
çÑ íÜÉ ÜçÄK cçääçï íÜÉ ~ÇîáÅÉ ~åÇ ï~êåáåÖë éêçîáÇÉÇ
ïáíÜ íÜÉ éêçÇìÅíK
j~äÑìåÅíáçåë ~êÉ ÖÉåÉê~ääó Å~ìëÉÇ Äó ãáåçê Ñ~ìäíëK
_ÉÑçêÉ Åçåí~ÅíáåÖ íÜÉ qÉÅÜåáÅ~ä ^ëëáëí~åÅÉ pÉêîáÅÉI
ÉåëìêÉ óçì Ü~îÉ êÉ~Ç íÜÉ ÑçääçïáåÖ êÉÅçããÉåÇ~íáçåë
~åÇ ï~êåáåÖëK
Measure
Use other electrical appliances to check if there has been
a break in the electric power supply.
Check that the appliance has been connected correctly
according to the connection drawing.
If the checks above do not resolve the malfunction,
contact the Technical Assistance Service.
Dry the control panel area or remove the object.
Disconnect the hob from the mains. Wait
a few seconds before connecting it again.
If the indication continues, notify
the Technical Assistance Service.
Wait until the electronic system has cooled down
completely. Then press any symbol on the hob.
If the indication continues, notify
the Technical Assistance Service.
Wait until the electronic system has cooled down
completely. Then press any symbol on the hob.
If the indication continues, notify
the Technical Assistance Service.
The hotplate can be switched on again straight away.