Turning On The Power; Standby Mode; Turning Off The Power; Initial Auto Installation - Sharp AQUOS LC-26P55E Operation Manual

Quick guide

Turning on the power

Press a on the TV.
• The B indicator on the TV changes from red to green.

Standby mode

Press B on the remote control unit.
• The TV enters standby mode and the image on the screen
disappears.
• The B indicator on the TV changes from green to red.

Turning off the power

Press a on the TV.
• The B indicator on the TV gradually turns off.
• When the TV is turned off by a, you cannot turn on the
power by pressing B on the remote control unit.
Display status indicator
Off Power off
Red The TV is in standby mode.
Green The TV is on.
NOTE
• If you are not going to use this TV for a long period of
time, be sure to remove the AC cord from the power outlet.
• Weak electric power is still consumed even when a is
turned off.

Initial auto installation

When the TV powers on for the first time after purchase,
the initial auto installation is invoked. You can
automatically set language, country and channels in
successive operations.
NOTE
• The initial auto installation functions only once. If the initial
auto installation is not completed, (ex: When menu screen
disappeared by not operating for a few minutes, when
the power shut down, etc.), try Auto Installation from the
Setup menu. (See page 14.)
• The initial auto installation stops by pressing RETURN.
1
Setting the on-screen display language
1 Press a/b/c/d to select the desired language
listed on the screen.
2 Press OK to enter the setting.
2
Setting the country or area
1 Press a/b/c/d to select your country or area
listed on the screen.
2 Press OK to enter the setting.
• The programme auto search starts at the same time.
After this setting, auto search starts with the following
order.
1 Programme auto search
2 Auto labelling
3 Auto sorting
4 Preset download
You do not need to do anything during the auto search.
The setup menu disappears and you can watch the
programme on channel 1.

Using the programme list

You can also select the desired channel from
programme list instead of using 0-9 numeric buttons
r /s r r s ). s s
r s
or P (r
1
Press OK when no other menu screen is
displayed.
2
Press a/b to select the desired channel to tune
in, and then press OK.
3
Press END to exit the Programme List.
7