Table of Contents
Advertisement
17
Axle
Bushing
Groove
Rear Fork Arm
Wheel
(with Hex Bushings)
Back View
• Position the vehicle assembly so that the back is
facing you.
• While holding the hex bushings in place, position the
wheel between the rear fork arms of the vehicle frame.
• Slide the wheel axle (with axle bushing) through one
rear fork arm, through the wheel (with hex bushings)
and out through the other rear fork arm. Make sure the
wheel axle bushing fits into the groove in the fork arm.
18
.437"
.437 Cap Nut
• Slide an axle bushing (tube side first) onto the end of
the wheel axle. Make sure the flat end of the axle
bushing fits into the groove in the fork arm.
• Fit a .437 (large diameter) cap nut on the end of
the wheel axle.
• Support the opposite end of the wheel axle and tap the
.437 cap nut with a hammer to secure it on the end of
the wheel axle.
• Pull on the .437 cap nut to make sure the rear wheel
assembly is secure.
Vehicle
Frame
Rear Fork Arm
Axle Bushing
Tube Side
.437 (Large
Diameter)
Cap Nut
Wheel
Axle
Back View
Assembly
19
Back View
• Lift the pretend buckles on a saddlebag to open
the saddlebag.
• Fit the tab on the back surface of the saddlebag into the
notch on one side of the rear fender.
• Insert three #8 x
inside of the saddlebag.
Note: The lower screw inserts through holes in the
saddlebag and vehicle body, and then attaches to the
vehicle frame. Make sure all the screw holes are aligned.
• Tighten the screws using a Phillips screwdriver.
Do not over-tighten.
• Repeat this step to assemble the other saddlebag to the
other side of the rear fender.
20
• Position the vehicle frame so that the front faces you.
• Fit a steering bushing underneath the neck of the
vehicle frame.
• Insert a #8 x
bushing and into the neck. Tighten screws using a
15
Phillips screwdriver. Do not over-tighten.
Saddlebag
Notch
3
/
" screws through the holes on the
4
Vehicle Frame
3
/
" screw through each side of the steering
4
Tab
Neck
Steering
Bushing
Front View
Advertisement
Table of Contents
