Quick Start Guide - Intermittent Pilot Systems - Empire Comfort Systems VFL20IN3 series Owner's Manual

Quick Start Guide - Intermittent Pilot Systems
To START the Fireplace:
If the pilot is NOT lit:
1. At the same time, press the "OFF" and high flame buttons and release once there is an
audible "beep" sound.
2. The pilot will ignite on the sixth beep. You may hear a clicking sound around the same
time as that beep, this is normal.
3. There will be a total of 14 beeps. The main burner will ignite approximately 15 seconds
after the pilot.
If the pilot IS lit.
1. To ignite the burner, press the high flame button (there will be a beep) for approximately
5 seconds until there is a soft click, then release the button.
To ADJUST the Flame Height
1. Press and hold the upper right button for a higher flame.
2. Press and hold the lower right button for a lower flame. Note: If you hold the lower right
button for too long, the flames on the main burner will go out, but the ignitor will stay lit.
To SHUT OFF the Fireplace
1. To completely shut off the burner and ignitor, press and hold the "OFF" button until the
unit "beeps." The flames will go on the burner out once any lingering gas is used up.
2. To shut off the burner but keep the ignitor on, push the low flame button (bottom right) for
10 seconds and then release.
FOR MORE INFORMATION, SEE OPERATION INSTRUCTIONS.
VFL(20,28)IN7 Remote Quick Start Instructions: Cut out this page and keep it near your remote.
28040-5-1211 Page 3