Page 2
Read this manual prior to initial operation of the product! Dear Customer, We hope that your product, which has been manufactured in modern facilities and passed through a strict quality control procedure, will give you very good results. We advise you to read through this manual carefully before using your product and keep it for future reference.
Important safety information This section includes safety information that will supply in order to decrease the risk of help protection from risks of personal injuries electric shock. or materialistic damages. Failure to follow • Do not make any changes on the plug these instructions shall cause any warranty and supplied with the product.
conditions. instructions. • Do not tamper with the controls. • Underwear that contains metal • Do not perform any repair or part replacing reinforcements should not be placed in procedures on the product even if you a dryer. Damage to the dryer can result if know or have the ability to perform unless metal reinforcements come loose during it is clearly suggested in the operating...
Installation Refer to the nearest Authorised Service Agent for installation of your product. Preparation of location and electrical installation for the product is under customer’s responsibility. Installation and electrical connections must be carried out by a qualified personnel. Prior to installation, visually check if the product has any defects on it.
Never unscrew the adjustable feet from their housings. Electrical connection Connect the machine to a grounded outlet protected by a fuse of suitable capacity as stated in the technical specifications table. Our company shall not be liable for any damages that will arise when the machine is used on a circuit without grounding.
Transportation of the machine 1. Unplug the machine from the mains. 2. Remove the water drain (if any) and chimney connections. 3. Drain water remained in the machine completely before transportation. Disposing of the old machine Dispose of your old machine in an environmentally friendly manner.
Initial preparations for drying Things to be done for energy A B C saving: • Make sure that you operate the product at its full capacity but pay attention to not exceeding it. • Spin your laundry at the highest speed possible when washing them.
Correct load capacity vapor. • Do not dry items cleaned with industrial chemicals in the dryer. • Do not dry your unwashed laundry in the dryer. • Items soiled with cooking oils, acetone, alcohol, fuel oil, kerosene, stain remover, turpentine, paraffin and paraffin removers must be washed in hot water with plenty of detergent before being dried in the dryer.
Following weights are given as examples. Approximate Home articles weights (g) Cotton quit covers (double) 1500 Cotton quit covers (single) 1000 Bed sheets (double) Bed sheets (single) Large tablecloths Small tablecloths Tea napkins Bath towels Hand towels Approximate Garments weights (g) Blouses Cotton shirts Shirts...
Selecting a Programme and Operating Your Machine Control panel 5. Programme selection knob 1. Filter cleaning warning light Used to select a programme. Warning light turns on when the filter is full. 6. Start/Pause/Cancel button 2. Program follow-up indicator Used to start, pause or cancel the Used to follow-up the progress of the programme.
Preparing the machine programme. It dries at a lower temperature compared to the cottons programme. It is 1. Plug in your machine. recommended for your synthetic laundry (such 2. Place the laundry in the machine. as shirts, blouses, synthetic/cotton blended 3.
Page 13
•Refresh Only ventilation is performed for 10 minutes without blowing hot air. You can air your clothes that have been kept at closed environments for a long time thanks to this program to deodorize unpleasant odors. •Timer programs You can select one of the 10 min., 20 min., 40 min.
Water tank started. Progress of program Warning light starts flashing when the tank is Progress of a running program is shown filled with water. The dryer stops operating if through the program follow-up indicator. the warning light turns on when a programme At the beginning of every program step, the is running.
lights do not turn on when the programme Child-proof lock is deactivated when the is cancelled by turning the programme machine is restarted by pressing the On/Off selection knob. Only the drying light turns button. on and the machine remains in hold until a new programme is selected and the “Start/Pause/Cancel”...
End of programme The “End/Anti-creasing”, “Filter cleaning” and “Water tank” warning lights on the programme follow up indicator will turn on when the programme comes to an end. The door can be opened and the machine becomes ready for a second cycle.
Maintenance and cleaning Filter Cartridge / Door Inner Surface Lint and fibres released from the laundry to the air during the drying cycle are collected in the “Filter Cartridge”. Sensor Such fibre and lint are generally formed during wearing and washing. Always clean the filter and the inner surfaces of the cover after each drying process.
Water tank; For the condenser; The moisture in the damp laundry is taken from Hot and humid air in the condenser is cooled the laundry and condens ed. Drain the water with the cold air from the room. Thus, the tank after each drying cycle or during drying humid air circulating in your dryer is condensed when “Water tank”...
Page 20
4. Clean the condenser by applying pressurized water with a shower armature and wait until the water drains. 5. Place the condenser in its housing. Fasten the 2 locks and make sure that they are seated securely. 6. Close the kick plate cover. 20 EN...
Suggested solutions for problems Drying process takes too much time • Meshes of the filter may be clogged. Wash with water Laundry comes out wet at the end of drying. • Meshes of the filter may be clogged. Wash with water. •...
Need help?
Do you have a question about the ASC71S and is the answer not in the manual?
Questions and answers