Table of Contents
Advertisement
1.
Maintain labels and nameplates on the Sump Pump. These carry important
information. If unreadable or missing, contact Harbor Freight Tools for a replace-
ment.
2.
Use the right product for the right job. There are certain applications for
which this product was designed. Do not use small equipment, tools, or attach-
ments to do the work of larger industrial equipment, tools, or attachments. Do
not use this product for a purpose for which it was not intended.
3.
WARNING!
Pump from its power source before handling or making any adjustments. Always
wear non-skid rubber boots when water is on the floor and you must unplug the
Sump Pump. Never allow the Motor to get wet. Make sure the electrical power
source is a separately fused, grounded, 3-wire type outlet of 15 AMP capacity.
DO NOT REMOVE THE GROUND PRONG OR PLUG. DO NOT USE AN
EXTENSION CORD.
4.
WARNING! Always arrange a "drip loop" in the Power Cord (1) con-
necting the Sump Pump to a 115 volt, grounded, electrical outlet. A drip
loop is that part of the Power Cord below the level of the outlet to prevent water
from traveling along the Power Cord and coming in contact with the outlet. If the
Power Plug or electrical outlet does get wet, do not unplug the Power Cord.
Disconnect the fuse or circuit breaker that supplies power to the Sump Pump.
Then, unplug the Power Cord and examine for presence of water in the outlet
(See Figure C.)
FIGURE C
5.
Do not pump hazardous materials. Do not pump explosive or flammable
materials such as fuel oil, kerosene, gasoline, etc. Do not pump in close proxim-
ity to flammable or explosive materials. Do not pump fats, oils, salt or waste
water. The Sump Pump is designed to move clean or dirty water only. Do
not pump water over 140 degrees fahrenheit.
SKU 92274
For technical questions, please call 1-800-444-3353.
SPECIFIC SAFETY RULES
Risk of electrical shock. Always disconnect the Sump
WATER DRIPS OFF CORD,
AWAY FROM OUTLET.
PAGE 7
Advertisement
Table of Contents
