Electrical Connection - Smeg ELECTRONIC WASHING MACHINE User Manual

CHAPTER -3: SETTING UP

ELECTRICAL CONNECTION /

WATER SUPPLY CONNECTION
ELECTRICAL CONNECTION
Your washing machine works with 220-240V and 50Hz.
An earthed plug has been attached to the power cable of your
washing machine. It is essential to connect this plug to an
earthed 10 ampere socket. The fuse flow value of the
electricity line attached to this should also be 10 ampere. If you
have no such sockets and fuses in your house, call a qualified
electrician.
The guarantee will be invalidated by any damage that
could occur as a result of usage without earthing.
Insert the machine's plug to an earthed socket within easy
reach.
WATER SUPPLY CONNECTION
Depending on the features of your machine, there may be
single water inlet (cold) or double water inlet (cold/hot). The
white headed hose is for cold water inlet and red headed hose
is for hot water inlet (valid for machines with hot and cold water
inlet).
To prevent leakage from the connection joints, 1 (valid for cold
water inlet) or 2 (valid for machines with hot and cold water
inlet) seals are included in the hose packing. Fit these seals at
the end of water inlet hoses on the tap side.
Connect the white headed hose to the water inlet valve with
white filter and connect the red headed hose to the water inlet
valve with red filter (latter is valid in machines with hot and cold
water inlet). Hand tighten the plastic parts of the
Please call a qualified plumber for safer connections.
Water pressure of 0,1-1 MPa from your tap will enable your
machine to work more efficiently.(0,1 MPa pressure means
water flow of more than 8 litres in 1 minute from a fully opened
tap)
After connections are completed, check for the non-leakage of
the connection joints by turning on your tap completely.
Be sure that water inlet hoses are not folded, broken or
crushed.
10
connections.