Subscribe to Our Youtube Channel
Related Manuals for POLTI VAPORETTO SYSTEME PRO
Summary of Contents for POLTI VAPORETTO SYSTEME PRO
- Page 3 Fig.1 Fig.2 Fig.3 Fig.4 Fig.5 Fig.6 Fig.6a Fig.7 Fig.8 Fig.9 Fig.10 Fig.11 W1 W2 W4 Fig.12 Vaporetto System Pro - M0S08405 Edizione 2O07...
-
Page 4: Optional Accessories
VAPORETTO SYSTEM PRO KEY TO ACCESSORIES 1) Main switch A1) Accessory connection 2) Boiler switch A2) Handle 3) Low water level indicator A3) Safety button 4) Steam indicator A4) Suction push-button 5) Suction speed indicator A5) Steam push-button 6) Castors B1) Steam + suction hose 7) Tank cap B2) Unit plug... - Page 5 VAPORETTO SYSTEM PRO Read these instructions carefully before using the appliance. Polti S.p.A. reserves the right to change equipment or accessory specification wi- thout prior notice.
- Page 6 • If it is necessary to replace the power supply jects such as embers, ash or other material cable, please refer to the nearest Polti autho- in which combustion is taking place. rised service centre, since the use of a spe- •...
- Page 7 • Do not put any detergent or chemical sub- ture. stance in the boiler. Water by its nature con- Polti declines liability for any damage or ac- tains magnesium, mineral salts and other de- cident derived from any use of Vaporetto...
- Page 8 Use only original Polti products, as other • You can supply steam by pressing the steam brands might not be suitable for use in Polti button (A5) on the handle. At the same time appliances and could cause damage.
- Page 9 VAPORETTO SYSTEM PRO ing tank, this will be shown by the “out of water” switch (3) and you will also be warned by an You can wind up the power cable as shown in audible signal. fig. 8. In order to continue working, proceed as de- scribed in the section on "Preparation for use".
- Page 10 Bioecologico is sold by Polti dealers or by our with a cloth that has been treated with steam. authorised Assistance Centres.
- Page 11 VAPORETTO SYSTEM PRO cleaned. To lock the fitting into place move of the extension tubes (D). the two slides (E1) inwards. It is possible to combine the 120° accessory Do not apply steam directly to wooden sur- with the following accessories: faces.
- Page 12 MAXIMUM travel at the end of the 3 dots RECOMMENDED TECHNIQUE for STEAM iro- symbol on your Polti iron ning with Polti iron is APPLY steam (button W2) Steam ironing allowed--set the dial to its on the upstroke, then release button (W2) (so...
-
Page 13: Important Note
VAPORETTO SYSTEM PRO testing in order to find the jet which is more suitable to the fabric to be ironed. Before carrying out any type of maintenance make sure that the power cable has been dis- IMPORTANT NOTE connected from the mains. •... - Page 14 VAPORETTO SYSTEM PRO TROUBLE CAUSE SOLUTION The suction fan does not start No power supply Check the cable, plug and socket The boiler filling pump can be Air in the boiler circuit. Switch off the appliance, allow it heard working continuously to cool and repeat the opera- tions described in the “OPERA- TION”...
- Page 15 NOTE...
Need help?
Do you have a question about the VAPORETTO SYSTEME PRO and is the answer not in the manual?
Questions and answers