Maintenance And Care - Tecnik Dishwasher Instructions For Use Manual

en
Programme interruption
Carefully open the door, it could happen
that water splashes out of the
appliance. Only open completely when
the spray arm no longer turns.
If the programme is already in "drying"
mode, an acoustic signal reminds you
to close the appliance door or to abort
the programme.
Switch OFF the main switch
Indicator light goes out. The programme
remains stored.
If warm water is connected or if the
machine is already heated up and the
appliance door has been opened, leave
the door slightly ajar, then close it,
otherwise the appliance door can jump
open through the expansion.
In order to continue the programme
flow, switch the main switch ON again
and close the door.
Cancel programme (Reset)
Only when the master switch is ON.
Press the A and C programme
buttons simultaneously and hold them
pressed for approx. 3 sec.
The programme continues for approx.
1 min.
The PROGRAMME END indicator and
the indicator for the programme that
has just been terminated light up.
Set main switch
Close the detergent compartment
To restart the dishwasher, set main switch
to ON again and select desired
1
programme.
Changing the programme
It is possible to change the programme
selection after you have switched the
dishwasher on, provided that you have not
yet closed the door.
If it is necessary to change the programme
after this, the programme cycle that has
already begun (e.g. washing) will still carry
on to the end.
18
.
1
to OFF.
1
30

Maintenance and care

You can help prevent faults by checking
and maintaining your appliance regularly.
This will save time and reduce problems.
Therefore you should occasionally
examine the inside of your dishwasher.
Overall condition of the
appliance
Check the rinsing compartment for grease
and limescale deposits.
If you find any deposits:
Fill the detergent dispenser with
detergent. Start the empty appliance
with the programme which has the
highest rinsing temperature.
Clean the door seal:
Wipe the door seal regularly with
a damp cloth and remove any deposits.
Dishwasher salt
Check the LOW SALT indicator
. Top up with salt, if required.
24
Rinse-aid
Check the LOW RINSE-AID indicator
on the front panel or the level indicator on
the rinse-aid container
rinse-aid, if required.
Filters
The filters
25
food or other objects from getting inside
.
the pump. This residue can occasionally
clog up the filters.
The filter system consists of a filter
cylinder, a flat fine filter and, depending on
the model, a microfilter (*).
Inspect the filters for obstructions every
time the dishwasher has been used.
By unscrewing the filter cylinder, you
can remove the filter system. Remove
any food remnants and clean the filters
under running water.
4
. Top up with
29
prevent larger remnants of
or
5