Do you have a question about the Dishwasher and is the answer not in the manual?
Questions and answers
Brian
May 28, 2025
How recognise salt and rinse aid refill indicators
1 comments:
Mr. Anderson
May 28, 2025
On a Tecnik dishwasher, the salt refill indicator is labeled as indicator 4 on the control panel. When it lights up, it means you need to refill the salt. The rinse-aid refill indicator is labeled as indicator 5 on the front panel or can be checked using the level indicator on the rinse-aid container.
Delivery according to the installation and Immediately check the packaging and assembly instructions. dishwasher for any damage which may The dishwasher must NOT be have been caused in transit. Do not use connected to the power supply during a damaged appliance, but consult your installation.
Do not place any heavy objects or stand on the door when it is open. The Warning appliance could tip forward. The water inside the dishwasher is not Children could get locked in the appliance suitable for drinking. (risk of suffocation) or get stuck in other positions.
* on applicable models Nameplate * not on all models You will need to purchase the following before using the dishwasher for the first time: – special salt for use in dishwashers – detergent – rinse-aid Only use products, which are suitable for...
B . In order to rinse dishes and glasses Each depression of the button satisfactorily, the dishwasher requires soft increases the set value by one (0–3). water, i.e. containing little or no lime, If buttons A , B and C illuminate,...
Unscrew the lid on the salt container Do not pour detergent into the container for special salt. This Before you use the dishwasher for the first would destroy the water time, pour approx. 1 litre of water into the softener.
Close the lid, ensuring that you hear it the panel (on applicable models) or snap closed. dispenser has not illuminated, there is sufficient rinse-aid in the dishwasher. Note Use only rinse aid for domestic LOW RINSE-AID indicator dishwashers. Spilt rinse aid may result in excessive foam formation in the next rinse cycle.
To prevent damage, take glass and cycle. Even some types of glass (e.g. cutlery out of the dishwasher as soon crystal glass objects) may become cloudy as possible after the programme has after many rinse cycles. Completely ended.
Scrape off any large amounts of left-over food. It is not necessary to rinse the dishes under running water. Place objects in the dishwasher in such a way that items such as cups, glasses, pots/pans, etc. are stood upside down,...
Spray head for baking sheets * Shelf * * on applicable models * not on all models Please refer to the drawings enclosed in Lean tall glasses and those with long the envelope stems against the shelf – not against other Large baking sheets or grids can be items to be washed.
Page 13
Top basket with upper and lower roller pairs Pull out the top basket. Remove the top basket and re-attach it to the upper or lower rollers. To raise the basket, take hold of the basket on the upper edge and pull upwards.
15 ml up to the bottom line and 25 ml up to washing-up liquid!) the middle line. When the compartment is full it contains 40 ml. Nowadays there are three types of dishwasher detergent available: 40 ml 1. those containing phosphates and 25 ml chlorine, 2.
Page 15
If you wish to use these combined order to products, please read the instructions determine where the tablets should be carefully and heed any notes on the placed inside the dishwasher (e.g. in packaging. cutlery basket, detergent compartment, etc.). Contact the manufacturer of the cleaning...
If only a small number of Apart from this, the end of the programme dishes have been loaded into is indicated by a buzzer. This function can the dishwasher, selecting a be changed as follows:– programme that operates at the next lowest temperature Hold down the function button C and will usually suffice.
Close the detergent compartment the pump. This residue can occasionally To restart the dishwasher, set main switch clog up the filters. to ON again and select desired The filter system consists of a filter programme.
Spray arms Lime and remnants of food in the washing water can block the nozzles in the spray arms and the arm mountings . Inspect the nozzles in the spray arms for blocked holes due to remnants of food. If necessary, pull the lower arm upwards and lift it off.
The water is no longer pumped Experience has shown that you can out of the dishwasher and it can be seen resolve most problems that arise during covering the filter.
Page 21
... during washing Caution Unusual amount of foam is created Do not forget that repairs Normal washing up liquid has should only be carried out by a been poured into the rinse-aid qualified specialist. Improper container. repairs can lead to Remove any spilled rinse aid with considerable equipment a cloth as it could otherwise lead...
Page 22
Remnants of food are stuck to the Selected programme did not dishes, cutlery, etc. include drying function. Dishwasher was not loaded Amount of rinse-aid was set too properly. Jets of water could not low. reach all parts of the dishes, etc.
Customer Service Important information Please call your local service agent, if you Notes on waste disposal are not able to resolve any problem Old appliances still have some residual yourself. The name of your nearest service value. An environment-friendly method of agent is shown in the Customer Service disposal will ensure that valuable raw address list.
Installation Fresh water connection Using the enclosed parts, connect the The dishwasher must be connected by fresh water connection to the tap a qualified technician to ensure correct according to the installation instructions. operation. The specifications for supply, Ensure that the fresh water connection is drainage and connected load must fulfil not kinked, crushed or twisted.
Pull out appliance and carefully withdraw hoses at same time. Transporting the dishwasher Drain water from the dishwasher. Secure all loose parts. The appliance should only be transported in an upright position. If the appliance is not kept upright...
Need help?
Do you have a question about the Dishwasher and is the answer not in the manual?
Questions and answers
How recognise salt and rinse aid refill indicators
On a Tecnik dishwasher, the salt refill indicator is labeled as indicator 4 on the control panel. When it lights up, it means you need to refill the salt. The rinse-aid refill indicator is labeled as indicator 5 on the front panel or can be checked using the level indicator on the rinse-aid container.
This answer is automatically generated
Need sizes