Table of Contents
Advertisement
FITTING THE STABILITY BRACKET
It is recommended that if the appliance is to be
installed with a flexible supply pipe, a stability
bracket be fitted and is available from your supplier
(see Important Safety Requirements).
instructions should be read in conjunction with any
leaflet packed with the stability bracket.
1. Place the appliance in its intended position and
level appliance.
2. Mark off 250mm from the left hand side of the
appliance as shown in dimension 'A', Fig 4a.
This is the centre line of the fixing bracket.
3. Draw a line from the front edge of the feet (see
Fig.3a) and remove appliance from its position.
Mark off dimension 'B' (see Fig.4a) back from
this line on the centre line of the bracket to
locate the front edge of the lower bracket. Fix
lower bracket (with two fixing holes) to the floor
then measure the height from floor level to
engagement edge on back of appliance,
dimension 'C' of Fig. 4b.
4. Assemble upper bracket to lower bracket so that
the underside of bracket is dimension 'C' + 3mm
above floor level. (See Fig. 4b)
Reposition appliance and check that top bracket
engages into appliance back as shown in Fig.
4b.
THE BATTERY
1. The battery is located at the front left hand side
of the bottom storage compartment.
2. To gain assess to the battery, open the storage
compartment and lift up the battery holder lid.
3. Fit the new battery ensuring (+) terminal is next
to the (+) sign on the battery. See Fig. 5.
4. Close the lid of the battery holder.
PRESSURE TESTING
1. The oven injector is used as a pressure test
point.
Remove the oven furniture.
burner box retaining clips (one spring clip from
each side) and remove box front cover. Replace
one clip back into the right hand side of the
burner box. Remove oven burner by removing
the spring clip from the right hand side of the
oven burner and slide burner off injector, whilst
easing it forward and taking care not to strain the
F.S.D. phial.
2. Connect the pressure gauge to the oven injector.
These
Remove oven
26
20mm
100mm
250mm
(
)
A
Fig.4a.
Fig.5.
(C)
Fig.4b.
Advertisement
Table of Contents
