Table of Contents
Advertisement
CONNECTING TO GAS SUPPLY
This appliance is designed to be installed with an
appliance flexible connection only. Supply piping
should not be less than R
the Rc ½ (½" B.S.P.) female threaded entry pipe
located just below the hotplate level on the rear left
hand side of the appliance. NOTE: ONLY LIQUID
SEALANTS TO BE USED WHEN INLET GAS PIPE
IS FITTED I.E.: DO NOT USE P.T.F.E. SEALANT
TAPE. Carry out a gas tightness test after
connecting to the gas supply.
connector must be fitted in the shaded area
indicated in Fig.2. Take into account that it must be
possible to pull the appliance forward sufficiently.
Ensure the hose does not become trapped when
pushing the appliance into position.
IMPORTANT: FLEXIBLE TUBING USED MUST
COMPLY WITH BS.669 CURRENT EDITION.
LPG Flexible connections must be a type suitable for
L.P.G and capable of operation up to 50 mbar and
carry a red stripe, band or label.
FITTING THE STABILITY BRACKET
It is recommended that if the appliance is to be
installed with a flexible supply pipe, a stability
bracket be fitted and is available from your supplier
(see Important Safety Requirements).
instructions should be read in conjunction with any
leaflet packed with the stability bracket.
1. Place the appliance in its intended position and
level appliance.
2. Mark off 250mm from the left hand side of the
appliance as shown in dimension 'A', Fig 3a.
This is the centre line of the fixing bracket.
3. Draw a line from the front edge of the feet (see
Fig.3a) and remove appliance from its position.
Mark off dimension 'B' (see Fig.3a) back from
this line on the centre line of the bracket to
locate the front edge of the lower bracket. Fix
lower bracket (with two fixing holes) to the floor
then measure the height from floor level to
engagement edge on back of appliance,
dimension 'C' of Fig. 3b.
4. Assemble upper bracket to lower bracket so that
the underside of bracket is dimension 'C' + 3mm
above floor level. (See Fig. 3b)
Reposition appliance and check that top bracket
engages into appliance back as shown in Fig.
3b.
3
/8. Connection is made to
The gas bayonet
These
50 100
All dimensions in mm
(
)
A
250mm
Fig.3a.
31
400
Fig.2.
100mm
(C)
Fig.3b.
Advertisement
Table of Contents
