Index Safety instructions ..Detergents ....Getting to know your dishwasher Opening and closing the door Before using your appliance Adjusting the appliance .
Safety instructions Installation Install and connect the appliance Delivery according to the installation and Immediately check the packaging and assembly instructions. dishwasher for any damage which may The dishwasher must NOT be have been caused in transit. Do not use connected to the power supply during a damaged appliance, but consult your installation.
During normal use If a fault occurs Repairs or other work on the dishwasher should only be carried out Warning by a qualified specialist. Knives and other utensils with sharp points The dishwasher must be disconnected must be loaded in the basket with their from the electricity supply before any points down or in a horizontal position.
Getting to know your Operating principle, display with buttons dishwasher Diagrams of the control panel and the Auto Wash interior of the appliance can be found Options Start in the envelope at the front. Individual positions are referred to in the text.
Before using your appliance Providing operating materials for the first time To operate the dishwasher you will require salt (only for appropriate water Before you can use your appliance for the hardness, see chapter “Adjusting first time, you must select the language. the softening system”), When the appliance has been switched rinse aid,...
Filling with salt Note If the degree of hardness of your tap water corresponds with value on the appliance (see chapter “Adjusting the softening system”), it is not necessary to fill the dispenser with salt, as salt is not used during operation of the dishwasher.
Setting up the water If you would nevertheless like to set the water softening system manually, softener proceed as follows: Find out the degree of hardness of your In order to provide satisfactory rinsing tap water. Your water supply company results, the dishwasher requires soft water, or customer service will assist you.
Filling with rinse aid Rinse aid is used in washing mode to ensure that glasses are sparkling and utensils are stain-free. When the appliance is switched on, low rinse aid level is indicated by ”Refill rinse aid”. You can add rinse aid either when the appliance door is completely open or –...
Unsuitable dishes Damage to glassware and other dishes You should not clean the Possible causes: following items in your type of glass or manufacturing process dishwasher: chemical composition of detergent Cutlery and dishes made of wood. They water temperature and duration of will leach out and become unsightly;...
Arranging crockery, glasses, Pots and pans etc. in the dishwasher Lower basket Loading the dishwasher Scrape off any large amounts of left-over food. It is not necessary to rinse the dishes under running water. Place objects in the dishwasher in such a way that items such as cups, glasses, pots/pans, etc.
Spray head for baking sheets * Shelf * * on applicable models * not on all models Please refer to the drawings enclosed in Lean tall glasses and those with long the envelope stems against the shelf – not against other Large baking sheets or grids can be items to be washed.
Page 14
Top basket with upper and lower roller pairs Pull out the top basket. Remove the top basket and re-attach it to the upper or lower rollers. To raise the basket, take hold of the basket on the upper edge and pull upwards.
Detergents CAUTION IMPORTANT NOTE Notes on detergents ON THE USE OF You may use any brand of liquid or powder COMBINED CLEANING detergent, as well as tablets, that have been specifically designed for use in PRODUCTS domestic dishwashers (do not use normal Please note the following when using washing-up liquid!).
Detergent dispenser with dosing aid The graduated detergent dispenser helps you add the correct amount of detergent. The lower and middle lines in the dispenser indicate15 ml and 25 ml of detergent respectively. The dispenser can be filled with 40 ml of detergent when the door is opened horizontally.
Opening and closing If using washing tablets, please refer to the washing tablets box where to place the door the tablets in the appliance (e.g. in the cutlery basket, detergent dispenser). To open the door, pull the door handle. Close the detergent dispenser. Slide To close the door, press the door shut the dispenser cover completely over until it “clicks”...
Adjusting the appliance Selecting a programme The following programmes can be Switching on the appliance selected in turn from the “Auto Wash” programme in the main menu: Turn on the tap fully. Switch on the appliance with the main Auto Super Wash – Auto Wash – Auto Delicate Wash –...
Programme overview Type of utensil e.g. porcelain, Hard- pans, Mixed Fragile Mixed wearing cutlery, glasses, etc. Type of food Coffee, Soups, Soups, Rinse if the remains cake, milk, potatoes, soufflés, utensils have e.g. sausage, cold pastries, sauces, been left for drinks, rice, eggs, potatoes,...
Programme data Selecting options/ standard settings The programme data (duration, energy and water consumption) can be found in Operating principle the summary of instructions and refers to standard conditions. Greater deviations may be caused by: Auto Wash different quantities of utensils Options Start inlet temperature of the water...
Timer programming Degree of drying You can delay the start of the programme If the “Degree of drying” option is by up to 24 hours in ½ hour steps. selected, “Normal drying” is displayed (factory setting). If the Timer programming option is selected, “Delay start 0:00 hrs”...
Language Standard programmes Before using the appliance for the first In addition to the wash programmes which time, you can change the selected can be selected from the main menu, the language (see chapter “Before using the following standard programmes can be appliance for the first time”).
Aqua sensor * The programme and other settings can still be changed for as long as the door is * on applicable models open after the “Start” button . has been The Aqua sensor is an optical measuring pressed. Return to the main menu by device which measures the turbidity of the pressing the “Back”...
Terminating the programme End of programme As soon as the programme has ended, Open the door. Open the door only slightly to prevent water from spraying the buzzer is emitted 5 times. out of the appliance. Open the door. “Finished” is briefly “Terminate programme”...
Maintenance and care You can help prevent faults by checking and maintaining your appliance regularly. This will save time and reduce problems. Therefore you should occasionally examine the inside of your dishwasher. Overall condition of the appliance Check the rinsing compartment for grease and limescale deposits.
Spray arms Pump * Lime and remnants of food in the washing on applicable models water can block the nozzles in the spray Larger remnants of food that have not arms and the arm been trapped by the filters and have been mountings .
Fault finding Some time after the programme has started, a continuous buzzer Resolving minor problems is emitted. yourself The appliance is not being filled with water. When the appliance door is Experience has shown that you can opened, “Check water supply!” is resolve most problems that arise during indicated.
Page 28
... with the appliance itself ... during washing Lower spray arm rotates with Unusual amount of foam is created difficulty Normal washing up liquid has Spray arm is blocked by small been poured into the rinse-aid items or food remains. container.
Page 29
... with the dishes, cutlery, etc. Dishes, cutlery, etc. have not been dried Remnants of food are stuck to the Selected programme did not dishes, cutlery, etc. include drying function. Dishwasher was not loaded Amount of rinse-aid was set too properly.
Customer Service Notes Please call your local service agent, if you Disposal of your old appliance are not able to resolve any problem Old appliances are not worthless rubbish. yourself. The name of your nearest service Valuable raw materials can be reclaimed agent is shown in the Customer Service by recycling old appliances.
General Installation Built-under and integrated appliances The dishwasher must be connected by which are subsequently installed as a qualified technician to ensure correct free-standing appliances must be operation. The specifications for supply, secured to prevent them from falling drainage and connected load must fulfil over, e.g.
Fresh water connection Disconnecting the dishwasher Using the enclosed parts, connect the Here too, it is important that tasks are fresh water connection to the tap carried out in the correct sequence: according to the installation instructions. always unplug the appliance from the Ensure that the fresh water connection is mains electricity first of all.