Oldsmobile Bravada 2002 Owner's Manual page 130

Training a Garage Door Opener with a
"Rolling Code" Feature (If Equipped)
If you have not previously programmed the hand
transmitter to HomeLink, see "Programming the
HomeLink Transmitter" listed previously. If you have
completed this programming already, you now need to
train the garage door opener motor head unit to
recognize HomeLink.
1. Find the "Learn" or "Smart" button on the
garage door opener motor head unit. The exact
location and color will vary by garage door opener
brand. If you have difficulty finding the "Learn" or
"Smart" button, refer to your garage door opener
owner's manual or contact the manufacturer of
- -
HomeLink at 1 800 355
www.homelink.com. Because of the steps involved,
it may be helpful to have another person assist in
programming the transmitter.
2-62
-
held
-
3515, or on the internet at
2. Press the "Learn" or "Smart" button on the
garage door opener motor head unit. An indicator
light will begin to flash when the motor head unit
enters the training mode.
Following this step, you have 30 seconds to
start Step 3.
3. Return to HomeLink in your vehicle and firmly
press and release the programmed HomeLink button
three times.
-
The rolling code garage door opener should now
recognize HomeLink. You may either use HomeLink
-
or the hand held transmitter to open the garage door.
If after following these instructions, you still have
problems training the garage door opener, contact the
manufacturer of HomeLink at 1
the internet at www.homelink.com.
- - -
800 355 3515, or on