Yamaha EQ-1100 Owner's Manual page 7

CONNECTIONS
(See Fig. 1.)
• When connecting your equipment, turn the power to
each unit off and make sure that you have correctly
connected the Left (L) and Right (R) channels.
• For the amplifier or receiver connections, please refer to
the amplifier or receiver owner's manual.
■ CONNECTING AN AMPLIFIER OR
RECEIVER
Check from the connection diagram that you have made
the correct connections. Please note that input procedures
and program source selection may vary according to the
capabilities of the amplifier or receiver and the
connections between it and this unit.
• To connect an integrated amplifier or receiver using
the ACCESSORY jacks (See Fig. 2.):
The ACCESSORY jacks are provided on some of
Yamaha's newest amplifiers and receivers.
1. Connect the SEND jacks of the ACCESSORY jacks to
the LINE INPUT of this unit.
2. Connect the RECEIVE jacks of the ACCESSORY jacks
to the LINE OUTPUT of this unit.
The program source selected with the integrated
amplifier's or receiver's input selector can be equalized.
• To connect an integrated amplifier or receiver
without using the ACCESSORY jacks (See Fig. 3):
1. Connect the REC OUT jacks of the TAPE jacks to the
LINE INPUT of this unit.
2. Connect tne TAPE PB jacks of the TAPE jacks to the
LINE OUTPUT of this unit.
The following operations can be carried out via the
amplifier or receiver:
Amp Program Source
With a REC Selected with the
OUT selector. REC OUT Selector.
\ With a TAPE Selected with the
MONITOR input selector.
switch.
■ CONNECTING A TAPE DECK
Connect the tape deck to the TAPE jacks. Connect the
TAPE PB jacks to the tape deck's LINE OUT terminal, and
the REC OUT jacks to the tape deck's LINE IN jacks.
FRONT PANEL PARTS
AND FUNCTIONS
(See Fig. 4.)
1. POWER switch
Press this switch to turn the unit ON. Press the switch
Setting
again to turn the unit OFF.
NOTE
Set the INPUT
Even when the equalizer is not in use, be sure that the
SELECTOR to
power cord is connected and the POWER switch is set to
TAPE.
ON.
Turn the TAPE
Failure to do so may result in no sound or distorted sound.
MONITOR switch
ON.
2. SPECTRUM ANALYZER/EQ LEVEL display
The spectra or equalizer levels are displayed.
The spectra are displayed using bars while the equalizer
levels are displayed using dots.
When a microphone is connected to the MIC jack, the
spectra of the microphone input are displayed.
3. Channel indicators
During equalizer display:
LEFT: Lights when the left channel is selected with the
channel button.
RIGHT: Lights when the right channel is selected with the
channel button.
LEFT RIGHT: The two light when the left and right
channels are selected with the channel button.
During analyzer display:
LEFT: Lights when the left channel is selected with the
channel button.
RIGHT: Lights when the right channel is selected with the
channel button.
LEFT + RIGHT: Light when the left and right channels
are selected with the channel button.
4. Preset No. indicator
The preset memory number (P1 to P7) is displayed.
5. MEMO indicator
When the MEMORY button is pressed, this indicator
flashes for about 5 seconds.