Yamaha EQ-1100 Owner's Manual page 6

ENGLISH
• Thank you for purchasing the YAMAHA EQ-1100/U
graphic equalizer.
CAUTION: READ THIS BEFORE OPERATING
YOUR UNIT.
1. The EQ-1100/U is a sophisticated graphic equalizer.
To ensure proper operation for the best possible
performance, please read this manual carefully.
2. Choose the installation location of your unit carefully.
Avoid placing it in direct sunlight or close to a source of
heat. Also avoid locations subject to vibration and
excessive dust, heat, cold or moisture. Keep it away from
such sources of hum as transformers or motors.
3. Do not install the unit on other component and do not
place the television set or color monitor on the unit.
4. Do not open the cabinet as this might result in damage
to the set, or electrical shock. If a foreign object should get
into the set, contact your dealer.
5. To prevent lightning damage, pull out the power cord
during an electrical storm.
6. When removing the power plug from the wall outlet,
always pull directly on the plug; never pull the cord itself.
7. Do not use force when using the switches.
8. When moving the set be sure to first pull out the power
plug and remove cords connected to other equipment.
9. Do not attempt to clean the unit with chemical solvent
as this might damage the finish. Use a clean, dry cloth.
10. Be sure to read the "Troubleshooting" section for
advice on common operating errors before concluding
that your unit is faulty.
11. Keep this manual in a safe place for future reference.
12. Voltage selector (General model only) The voltage
selector switch on the rear panel of this unit must be set for
your local mains voltage before plugging in the AC main
supply.
WARNING
TO PREVENT FIRE OR SHOCK HAZARD, DO NOT
EXPOSE THIS APPLIANCE TO RAIN OR
MOISTURE.
CAUTION: TO PREVENT ELECTRIC SHOCK DO
NOT USE THIS (POLARIZED) PLUG WITH AN
EXTENSION CORD, RECEPTACLE OR OTHER
OUTLET UNLESS THE BLADES CAN BE FULLY
INSERTED TO PREVENT BLADE EXPOSURE.
SPECIAL INSTRUCTIONS FOR BRITISH
MODEL
IMPORTANT:
The wires in the mains lead are coloured in
accordance with the following code.
Blue: NEUTRAL
Brown: LIVE
As the colours of the wires in the mains lead of this
apparatus may not correspond with the coloured
markings identifying the terminals in your plug, proceed
as follows. The wire which is coloured BLUE must be
connected to the terminal which is marked with the
letter N or coloured BLACK. The wire which is coloured
BROWN must be connected to the terminal which is
marked with the letter L or coloured RED.