Lenovo ThinkCentre E73z Hardware Maintenance Manual page 97

8. Lift the microprocessor straight up and out of the socket.
Notes:
a. Your microprocessor and socket might look different from the one illustrated.
b. Note the orientation of the microprocessor in the socket. You can either look for the small triangle
on one corner of the microprocessor or note the orientation of the notches
This is important when installing a new microprocessor on the system board.
Figure 29. Noting the orientation of the microprocessor in the socket
c. Touch only the sides of the microprocessor. Do not touch the gold contacts on the bottom.
d. Do not drop anything onto the microprocessor socket while it is exposed. The socket pins must be
kept as clean as possible.
Figure 30. Removing the microprocessor
9. Make sure that the small handle is in the raised position and the microprocessor retainer is fully open.
10. Hold the new microprocessor and align the notches
microprocessor socket, or align the small triangle
corresponding beveled corner of the microprocessor socket.
2 on it with the alignment keys in the
1 on one corner of the new microprocessor with the
2 on the microprocessor.
.
Chapter 9 Replacing FRUs
1
93