Download Print this page
Teac FD-235 Series Installation Manual

Teac FD-235 Series Installation Manual

3 1/2" 1.44 mb floppy disk drive

Advertisement

Quick Links

3 1/2" 1.44 MB Floppy Disk Drive
3 1/2'' diskette
insertion window
Activity indicator
Your FD-235 package includes:
* FD-235 3 1/2" floppy disk drive

* Installation Guide

Introduction
Thank you for purchasing the TEAC FD-235 Series 1.44 MB floppy disk
drive. This product is intended for use in IBM PC/AT compatible computers.
This quality drive will provide trouble-free operation for your computer
system if properly installed. PLEASE READ THE ENTIRE INSTALLATION
GUIDE THOROUGHLY BEFORE YOU BEGIN THE INSTALLATION.
Use a standard floppy controller card or the floppy connector (34 Pin) on
the motherboard.
TEAC FD-235 Series
Installation Guide
Eject Button

Advertisement

loading

Summary of Contents for Teac FD-235 Series

  • Page 1: Installation Guide

    * FD-235 3 1/2" floppy disk drive * Installation Guide Introduction Thank you for purchasing the TEAC FD-235 Series 1.44 MB floppy disk drive. This product is intended for use in IBM PC/AT compatible computers. This quality drive will provide trouble-free operation for your computer system if properly installed.
  • Page 2 Your system may also have a single ground wire attached to the floppy disk drive. Carefully disconnect all cables from your floppy disk drive. Remove original floppy disk drive. 4. Install the FD-235 Series 1.44 MB into an available drive bay. Rear View of FD-235 Pin #1 indicator stripe (red or blue) Flat “ribbon”...
  • Page 3 (Figure B) to complete installation. Cable’s colored-line denotes Line 1 to match to Pin 1 on drive and motherboard’s connectors. a. To configure as your A: drive, connect the FD-235 Series floppy drive to Connector A: on the flat “ribbon” cable. Connector A: is the end connector of the cable as shown in Figure B.
  • Page 4: Trouble Shooting

    Use correct disk. Drive may need service. Head seek error or drive out of Sector not found error. alignment. Bad media or drive. TEAC Tech Support: If you have questions on the floppy installation, please contact us: Phone: 323-727-4860 Fax: 323-869-8751 Email: dspdtsg@teac.com...