I have been an audiophile for more than 30 years, and have used and upgraded the TAG McLaren Audio home cinema experience many, many audio systems in that time. TAG McLaren Audio exists with one...
Home cinema provides an all involving cleaner signal and hence better clarity and Thank you for purchasing the TAG McLaren Audio five-channel amplifier 100x5R. sound field, with sound reaching the listener stereo imaging.This is true whether dealing...
190 watts into 2 ohms for short about their use in the 100x5R was made. three, four or all five channels of aluminium heatsink for excellent heat durations.
Page 6
20 to 20,000 Hz voltage and allows the signal path to be 100x5R in and out of standby, the user can cannot be heard, it can significantly distort direct coupled without any capacitors.This also switch off any of the 5 channels not...
Page 7
(such as our Cable AvantGarde The outer shell carries a polyurethane F3-10- SPK) including ” (10 mm) OFHC disk which protects the surface of future proof engineering spade contacts. furniture. The 100x5R can be upgraded in future...
Page 8
flat surface. Do not use in a cabinet or on a soft surface such as a carpet. If the 100x5R is going to be run at high levels for many hours at a time then it is not recommended that any other piece of equipment is placed on top of the 100x5R.
Page 9
The five channels of power amplification in the 100x5R are On the rear panel of the 100x5R you will find five pairs of TAG surround sound loudspeaker designed to drive the five surround channels. As a result of the McLaren Audio loudspeaker terminals.
‘mute’ button is pressed again. at first, until sound is replayed through the audio system. Sit back When the 100x5R is muted the bottom LED on the right front and enjoy! panel, above the power button, will illuminate.
Page 11
100x5R remains active to monitor the channel stereo without surround sound enhancement (such as status of the 100x5R and to wait for a ‘wake-up’ command from TAG McLaren Surround). the remote control. To provide this function certain buttons need to be operated in Pressing ‘standby amp’...
Page 12
Two buttons, directly below the label ‘DVD’ allow the user to DVD32R control the most frequently used functions of the TAG McLaren One of the flexible aspects of the 100x5R is that the micro- future proof Audio dvd player DVD32R.
Under some circumstances, you may experience an audible hum in your loudspeakers. Should you have any problems with Just like a high quality car, the performance of your 100x5R will running in hum in your system, please follow the steps below or contact improve during the first few hours of operation.
There is a fuse in the power socket on the back of your 100x5R. The only service you should do to your 100x5R is described on fuses service To change the fuse, unplug the power cable and carefully pull out the previous page.
This section is for those of you who really want to know the ‘insides’ of your 0.2 Hz - 87 kHz frequency response 100x5R. You will not miss out on any of the functions or performance of your (-3 dB) 100x5R if you choose not to read any further.
Page 16
technical data less than 1380 W power consumption 445 mm wide dimensions 139 mm high (including feet, 352 mm deep terminals and controls) We reserve the right to alter design and specification without notice. Specification may vary for different countries. trademark acknowledgements ‘Dolby’is a trademark of Dolby Laboratories.
Need help?
Do you have a question about the 100X5R and is the answer not in the manual?
Questions and answers