Panasonic TX-P42GT60Y Ehelp page 190

New Channel Message
(On / Off)
Selects whether to give a notification message when a new channel is found
or not.
Watching
For DVB mode
●
Service Replacement
(On / Off)
Set to On to display a message to switch to the available service (only
available in some countries).
For DVB-C mode
●
Signal Condition
Checks the signal condition.
Watching
Not valid in Analogue mode
●
Antenna System
(One LNB / MiniDiSEqC
Sets the antenna system to use plural LNBs for receiving several satellites.
Watching
This TV supports DiSEqC Version 1.0.
●
For DVB-S mode
●
LNB Configuration
Selects the satellite for each LNB.
Watching
For DVB-S mode
●
Attenuator
(On / Off)
Automatically reduces the DVB-C signal to avoid the interference.
If the DVB-C signal is too strong, the interference may occur. In this case,
●
set to On to weaken the signal automatically.
Tuning and editing channels
Tuning and editing channels
/ DiSEqC 1.0 / Single
Tuning and editing channels
Tuning and editing channels
- 190 -
New Channel Message
Signal Condition
Cable)
Auto Setup
Auto Setup