Panasonic SC-HT535 Operating Instructions Manual page 5

[HT845] [HT885]
[Note]
≥To prevent the speaker cables from being pulled out of the pipes, leave the plastic wrap on the pipes while assembling the speaker stands.
≥[HT885] The front and surround speaker pairs as well as the pipe pairs are different.
–Check the label on the rear of the speaker before attaching the pipe (➜ page 6).
–The pipe with the shorter cable is for the front speaker.
[HT845]
2 Front speakers
[HT845]
[HT885] 2 Front and
2 Surround speakers
1
Assemble the speaker stands.
1
Thread the speaker cable through the base.
For quicker threading, loosely fold the cable in half (do not
crease), pass the folded portion through the hole, and then pull
the rest of the cable through the base.
Plastic wrap
Leave the excess speaker
cable for connecting later.
2
Insert the pipe.
Pipe
Match the groove and these
holes with the base when you
Groove
insert the pipe.
Pipe support
Base
3
Secure the pipe to the base.
Ensure the screws are securely fastened.
Short screws
Before proceeding to the next step, please remove the plastic
wrap from the pipe.
∫ Preventing the speakers from falling over
Preparation
Attach screw eyes (not included) to secure the speakers to the wall
(➜ diagram right).
≥You will need to obtain the appropriate screw eyes to match the
walls or pillars to which they are going to be fastened.
≥Consult a qualified housing contractor concerning the
appropriate procedure when attaching to a concrete wall or a
surface that may not have strong enough support. Improper
attachment may result in damage to the wall or speakers.
To prevent the speaker from falling over, thread the string (not
included) from the wall to the speaker as shown and tie tightly.
[HT885] 4 Pipes
≥2kpipes with short cable:
2 Pipes
For front speakers
≥2kpipes with long cable:
For surround speakers
Cable
Base
Insert the pipe while gently
pulling on the speaker cable.
Phillips-head
screwdriver (not included)
[HT845] [HT845]
2 Bases 4 Long screws
[HT885] [HT885]
4 Bases 8 Long screws
2
Attach the stands to the speakers.
Ensure the stand is fastened on straight by gradually tightening the
top and bottom screws alternately until fully tightened.
Long screws
You can also attach to the lower rear of the speaker.
The height of the speaker can be changed when attaching the
stand to the upper rear or lower rear of the speaker.
3
Connect the speaker cables.
Twist off the vinyl ends of the
§
speaker cables.
_:
Copper
`:
Silver
Push!
§
If the speaker cables do not have vinyl
tips, directly connect them to the
terminals.
Press the speaker cable into the
groove.
If there is any excess speaker cable, thread the speaker cable
into the opening near the top of the pipe while pulling the speaker
cable from the bottom of the base.
4
Secure the speaker cables to the bases.
Press the speaker cable into
the base cover groove as far
as possible.
Cable
[HT535]
String (not included)
Rear of the speaker
[HT845] [HT885]
Screw eye (not included)
String (not included)
Rear of the speaker Approx. 150 mm
[HT845]
4 Short screws
[HT885]
8 Short screws
Pipe
Speaker
Rear of the speaker
Rear side of
base
Groove
Screw eye (not included)
Wall
Approx. 150 mm
Wall
RQT8225
5