SSANGYONG MUSSO SPORTS 2005 Owner's Manual page 133

WARNING
If you remove the bolt without
holding the tire and carrier, the tire
and carrier will drop suddenly so
keep in mind that you could be
injured. If necessary, position the
jack under the tire and carrier as
shown and slowly get it down by
using the jack.
Musso sports_RHD_ E_06.p65
7
Changing a Wheel
1. Remove the spare wheel from stowage
area with jacking tools.
2. Use the wheel wrench to loosen the
wheel nuts one turn each.
CAUTION
Do not remove any of the nuts until
you have raised that wheel off the
ground.
3. Insert the jack connection rod and the
wheel wrench into the jack.
4. Rotate the jack connection rod clockwise
to raise the lift head slightly.
5. Locate the jack according to the fig.
below.
Jack connection rod
Wheel wrench
IN CASE OF EMERGENCY 6–7
6. Place the jack vertically at the front or
rear jacking location closest to the wheel
you plan to change.
CAUTION
Do not attempt to raise vehicle until
the jack is in the proper position,
and secure both to the vehicle and
the ground.
7. Jack up the vehicle by rotating the jack
connection rod clockwise until the tyre
is off ground about 1inch (3cm).
(Front)
2005-04-26, ¿ÀÈÄ 3:19