Front Panel Connectors - SoundCraft GB2R User Manual

Mixing console

Hide thumbs

Table Of Contents

Table of Contents

level, and the pfl/afl signal is routed to the control room outputs and to the

headphones. This signal replaces the normal monitor signal. The PFL/AFL LED

(16) illuminates when this is happening.

Note: the 2-track input may also be routed directly to the main L-R mix via the

2 TRK TO MIX switch (17).

Stereo Returns

There are two stereo returns. Each one is fed from a pair of 1/4" jacks on the

rear connector panel. The inputs are electronically balanced. The stereo signal

is routed, via the LEVEL pot (18) to the Main Mix or the Sub groups via the MIX/

SUB switch (19)(GB2R 12-2 only, the GB2R 16 routes the signal to the main

mix busses).

A pre-level-control mono-sum of the input pair is routed, via the Aux 1 (or Aux2)

pot (20) to the Aux 1 or Aux 2 bus respectively.

PSU Monitor LEDs

These LEDS (21) confirm the presence of the correct voltage on the +48V and

the +/-17V power rails in the console.

Lamp

The 4-pin socket on the fascia, which is marked 'LAMP' (22), can be used for a

range of commercially-available gooseneck lamps. The socket provides a 12V

supply.