Test Run After Installation - Panasonic NA-168VX3 Operating Instructions & Installation Instructions

Test run after installation

After the appliance has been completely
installed where it is to be used, run the spin
cycle to check for water leaks, abnormal
noises, and whether the water gets
properly drained off.
Perform the following procedures
WITHOUT laundry in the drum.
1. Turn on the tap.
2. Close the door.
3. Press the On button, and then select
the Quick 50 programme.
4. Select the Spin only mode of the
Mode function, using the Option
button, and then press the Start
button.
Wait until the water drains out.
5. While holding down the
Help buttons, press the On button.
Help
6. When the following numbers are
displayed (3 seconds), press the Help
button.
8 : 88
The remaining time is displayed as below.
0 : 03
The test is run for about 3 minutes.
NA-168VX3_English.indb 41
Checking After Installation
Check the following:
- Is there any abnormal noise?
If so, make sure that the appliance is
level.
- Is there any water leakage?
If so, make sure that the hoses are
properly connected.
You may get the following errors:
- (U11) Unable to drain
Are the hoses properly connected?
Is the drain clogged?
- (U14) Unable to supply water
Have you properly connected the water-
supply hose and turned on the tap?
After recovering from an error, reopen and
reclose the door to resume the test.
and
Help
Installation Instructions - 41
2011-6-1 11:21:09