Panasonic NV-VP31EB Operating Instructions Manual page 17

Follow the steps described below.
1
Ensure TV Power, External unit Power and VCR/DVD Power are disconnected
from AC Mains socket.
2
Connect a 21-pin scart cable (fully wired) to the AV2 21-pin scart socket on the
VCR/DVD and to the 21-pin scart socket on the External unit.
Connect a 21-pin scart cable (fully wired) to the AV1 21-pin scart socket on the
VCR/DVD and to the 21-pin scart socket on the TV set.
3 Connect aerial to the Aerial in connector of the External unit.
Connect the External unit´s Aerial out connector to the VCR/DVD's RF IN (Aerial input).
Connect the VCR/DVD´s RF OUT (Aerial output) to the TV set's Aerial in connector.
4
Connect the External unit, VCR/DVD and TV set to the AC mains supply.
5
Switch on the TV set and VCR/DVD.
Set the VCR menu settings for AV2 according the connected External unit (See page 32).
6
Switch on the External unit. Then follow page 13 for VCR Auto Setup with 21-pin
Scart cable.
[RGB] means separate Red/Green/Blue colour signals. If you connect a TV equipped with RGB input
capability to the AV1 socket on this VCR/DVD, and a decoder equipped with RGB output capability to
the AV2 socket, RGB signals will pass through the VCR/DVD to the TV when the VCR/DVD is in
stand-by mode. The RGB signals cannot be recorded or produced by this VCR/DVD.
17