Optional Antenna Connections; External Unit Connections; Using An External Unit; Using Headphones (Not Included) - Panasonic SC-AK220 Operating Instructions Manual

Optional antenna connections

Use outdoor antenna if radio reception is poor.
FM outdoor antenna
75 Ω coaxial cable (not included)
1
2
1
2
3
•
Disconnect the FM indoor antenna.
•
The antenna should be installed by a competent technician.
AM outdoor antenna
AM outdoor antenna (not included)
5 -12 m
1
2
Run a piece of vinyl wire horizontally across a window or other
convenient location.
Leave the loop antenna connected.
Note
Disconnect the outdoor antenna when the unit is not in use.
Do not use the outdoor antenna during an electrical storm.

External unit connections

Rear panel of
this unit
(R)
•
An analog player with a built-in phono equalizer can be connected.
•
For details, refer to the instruction manual of the units which are to
be connected.
•
When units other than those described above are to be connected,
please consult your audio dealer.
FM outdoor antenna
(not included)
30 mm
Shield braid
15 mm
Core wire
AM loop
antenna
(included)
R L
(L)
Analog player
(not included)

Using an external unit

(See left for external unit connection.)
1. Press [AUX].
The unit comes on.
2. For listening: Proceed to step 3.
For recording: Press [a, REC] (recording starts).
3. Start playback from the external source. (For details, refer to the
external unit's instruction manual.)

Using headphones (not included)

Reduce the volume level and connect the headphones.
Plug type: 3.5 mm stereo
Note
Avoid listening for prolonged periods of time to prevent hearing damage.

Turning the demo function on/off

When the unit is first plugged in, a demonstration of its functions may
be shown on the display.
If the demo setting is off, you can show a demonstration by selecting
"DEMO ON".
Press and hold [DISP, –DEMO].
The display changes each time the button is held down.
NO DEMO (off) ↔ DEMO ON (on)
While in the standby mode, select "NO DEMO" to reduce power
consumption.
Note
DEMO function cannot be turned on when Dimmer is on.

Convenient functions

Remote control only
To dim the display panel
Press [DIMMER].
The display is dimmed and the indicators are turned off.
(The AC supply indicator remains on.)
Press [DIMMER] again to restore the display.
To mute the volume
Press [MUTING].
Press the button again to cancel.
"MUTING" goes out.
To cancel from the unit, turn [VOLUME] to minimum (--dB), then raise
it to the required level.
Muting is also cancelled when the unit is turned off.
13
RQT7533