Troy-Bilt TB32CS Operator's Manual page 12

MAINTENANCE AND REPAIR INSTRUCTIONS
7. Repeat procedures 4-6 with the second piece of line.
8. Hold the outer spool. Wind the inner reel
counterclockwise until approximately four (4) inches
(102 mm) of line remain (Fig. 18).
NOTE: Do not wind the inner reel before installing the
second piece of line.
9. If winding the line becomes difficult or the line jams,
pull the ends of the line from the spool (Fig. 19).
Continue winding the inner reel counterclockwise.
INSTALLING A PREWOUND REEL
1. Turn the Bump Knob counterclockwise and remove
the bump knob, spring and foam seal (Fig. 20).
Bump Knob
Foam Seal
Spring
Inner Reel
12
Fig. 18
Fig. 19
Fig. 20
2. Pull the old inner reel with existing line from the outer
spool.
3. Insert the ends of the prewound inner reel line into
the outer spool eyelets (Fig. 21). Push the new inner
reel, arrow side up, into the outer spool.
4. Hold the inner reel in place and install the bump
knob, spring and foam seal. Press down and turn the
bump knob clockwise. Grasp the ends and pull
firmly to release the line from the holding slots in the
inner reel (Fig. 19).
Releasing the Inner Reel
®
If the SpeedSpool does not release line correctly, pull
the ends of the line firmly from the spool (Fig. 19). If this
does not the release line, follow the Cleaning the
®
SpeedSpool instructions.
CLEANING THE SPEEDSPOOL®
Cleaning the SpeedSpool
• A jammed or excessive line must be removed
®
• The SpeedSpool becomes difficult to wind or does
not operate correctly when bumping the head on the
ground
1. Hold the outer spool, and unscrew the bump knob
counterclockwise (Fig. 22).
2. Pull out the bump knob, spring and foam seal
(Fig. 20).
3. Pull the inner reel with existing line from the outer
spool (Fig. 21).
4. Remove any existing line from the inner reel before
cleaning. Remove any debris or grass from the knob,
spring, inner reel and foam seal. Wash the inner reel
with warm soapy water (Fig. 23).
Fig. 21
®
may be necessary if:
Fig. 22