Advertisement
Operating Instructions
Read the enTIRe ImpORTanT
SaFeTy InFORmaTIOn section at the
beginning of this manual including
all text under subheadings therein
before set up or use of this product.
Controls
Drive Anvil
1.
Wear ANSI-approved safety goggles
and heavy-duty work gloves.
2. Clean and/or repair the threads that will be
tightened. Damaged or dirty threads will
result in a misleading torque reading.
3. Select the desired socket and verify it fits
properly on the nut or bolt being tightened.
4. Press the socket firmly onto the drive anvil.
SKU 00239
Knurled Handle
Torque Settings
Lock Knob
For technical questions, please call 1-800-444-3353.
5.
Turn the Lock Knob at bottom of the
Handle counterclockwise until it stops.
6. Turn the handle to set the torque.
To set to 55, for example:
70
50
a.
Turn the knurled handle (CW or CCW) until
the "0" graduation on the bevel edge lines
up with 50. See illustration (A), above.
70
50
The 50 line is shown in grey because
it will likely be hidden at this point.
b.
Continue turning the knurled handle about
a half turn clockwise until the "5" graduation
mark lines up with the centerline. It is now
set for 55. See illustration (B), above.
Lock Knob
80
60
2 0
8
1
9
(a)
80
60
7 5
3
6
4
(B)
Page 3
Advertisement
