Installation; Environment; How To Clean The Filter; Connecting The Drain Hose - Samsung WT80J8 Owner's Instructions Manual

INSTALLATION

ENVIRONMENT

Leave some space
If the washer is placed on an uneven or weak
surface, noise or vibration may be occured.
(Allowable is 2°)
Never install the washer near water.
Do not place the washer in steamy rooms or
where the washer is directly exposed to rain.
Moisture may destroy the electrical insulation
and cause an electrical shock hazard.
Avoid direct sunlight or heating devices.
As plastic and electrical components are
affected by direct heat, never place the
washer near heaters, boilers,etc.
Do not place under direct sunlight.

CLEANING THE MACHINE

CLEANING THE LINT FILTER
Lint Filter
CLEANING THE WASH TUB
Wipe off strains on the cabinet and operation panel
with soft cloth.
Do not use benzene, thinners, cleanser, or wax, nor
scrub the washer with a brush.
Painted surfaces or plastic parts will be damaged.

HOW TO CLEAN THE FILTER

3. Remove dirts and rotate
locks in position.
Remark : Should be cleaned
Filter at least 1 time a week.

CONNECTING THE DRAIN HOSE

Insert the drain hose(a) and push it tighly to be
connected as arrow direction.
Install the drain hose(A) about 70~80cm above the
ground for pump model.
OVERFLOW FILTER
CLEANING THE COVER WINDOW SPIN
1. Rotate the cover window spin clockwise
and pull out.
2. Cleaning the cover window spin.
3. Insert the cover window spin back and
rotate it counterclockwise until locks in
positon.
Remark : Should be cleaned the cover window spin
at least 1 time a month.
Close
3
(In case drain pump)
(WITHOUT PUMP)
Open
Cover Window Spin