Channel Tuning / Correcting Interferences; Setting Time And Date - Panasonic NV-SV121 Series Operating Instructions Manual

Channel tuning / Correcting interferences

If you decide to just use the RF coaxial cable to connect the TV set you must adjust the
video output channel with the TV set's input channel.
Screen Display
Turn on your television set.
Turn on the VCR by pressing the Stand-by/on switch.
VCR Ch:36
Press MENU for about 5 seconds. The preset channel is
displayed on the VCR-display.
Adjust television set to show the test picture.
Test pattern
If there are any interferences select another channel on the
VCR Display
television set and the VCR.
Press the CH button to change the channel
(e.g. Channel 39). Fine-tune television set until
RF Output Channel a clear picture is displayed.
Confirm with ENTER.
Continue VCR Auto Setup (Automatic tuning).
RF Output Channel
The VCR will not initiate the VCR Auto Setup if it was run once
before.
VCR Ch:39
Reset the device to factory defaults (page 17). Upon doing so
you will be able to start VCR Auto Setup again.
Press EXIT to abort VCR Auto Setup. You can run VCR Auto
Test pattern
Setup again at another time.
If a 21-pin Scart cable is used, please adjust the following
settings to disable the VCR´s RF-output channel.
Press MENU for about 5 seconds. The preset channel will be
...
21 69
displayed on the VCR-display.
(RF OFF)
Press channel select buttons CH or 0 to invoke [- -].
Confirm with ENTER.

Setting Time and Date

Menu
Timer recording
Tuning
Clock set
Others
Language : English
ENTER
: select :
EXIT
: exit
TRACKING/V-LOCK
Automatic tuning
CH
Clock set
AUTO
Time : 12 : 00 : 00
Date : 11. 6. 04
ENTER
: select
MENU EXIT
: return
Manual tuning
Clock set
MANUAL
Time : 12 : 00 : 00
Date : 11. 6. 04
ENTER
: select
MENU EXIT
: return
Press MENU,
the Menu screen appears.
With select Clock set.
Press ENTER.
access
Select [AUTO] and confirm with
ENTER.
If the device does not find a TV
station broadcasting the time
signal, set Time and Date manually.
access
:
: exit
Select [MANUAL] and confirm with
ENTER.
With or
1
enter Time and Date, then store
with ENTER.
: access
: exit
...
2 3 0
11