Table of Contents
Advertisement
2.
Using a small flat head screwdriver or similar tool, pull out the Fuse (12) from the
Fuse Holder (18)-see Figure 1.
3.
Do not replace with a different size fuse, as this may result in excessive heat build
up and explosion, which can damage the CarHeater/Fan and cause injury.
1.
The Heater/Fan can be permanently mounted to the vehicle using Mounting Screws
(21) or can be mounted using the Adhesive Tape as desired. Mount the Heater
Fan so that it is out of direct sunlight. Do not mount the Heater Fan on upholstered
seats or flammable surfaces.
2.
When using Mounting Screws, make certain that all drilling paths are clear of elec-
trical lines, cables, wire and any other obstructions.
3.
Make certain that there is sufficient length in the Power Cord to reach the Cigarette
lighter.
4.
Use the Mounting Base (6) as a guide to mark two holes in the desired surface.
Drill holes in the desired surface.
5.
Align the holes in the Mounting Base (6) with the drilled holes. Mount the Mounting
Base (6) using Mounting Screws (21).
6.
When using the Adhesive Tape (21) mount as follows:
Make certain that there is sufficient length in the Power Cord to reach the Cigarette
lighter. Wipe the Base (6) with alcohol for a grease-free surface. Peel off one face
of the Adhesive Tape (21). Place the tape on the face of the Base (6) and press
down and hold for one minute to adhere.
7.
Prepare the mounting surface on the car following the same procedure as indicated
in the above mentioned paragraph. Peel the tape backing carefully and position
the Base (6) on the surface and press into place. Leave in place for an hour before
use.
For technical questions, please call 1-800-444-3353.
SKU 96144
Mounting
Page 5
Advertisement
Table of Contents
