Table of Contents
Advertisement
Wire Tension
Control and Lock
Bracket "A"
Current Collector (with
Wire Routing Housing)
Feed Control
Wheel
Wire Routing
Housing
3.
Attach the Current Collector (with Wire Routing Housing) to Bracket "A" and tighten.
Refer to photos above.
4.
Press the white Gas Tube onto the black outlet "B".
5.
Plug the white tube Square Connector "C" into the matching receptacle "D".
6.
Wind (or place) the welding wire onto the Wire Spool (not shown), and mount the Wire
Spool onto the Wire Feed Axis Mechanism. See photo on next page.
7.
Guide the welding wire into the Wire Routing Housing until it passes the Feed Control
Wheel, and into the Torch Cable.
8.
Connect a 220 VAC plug (not supplied) to the line cord. This step must be done by a
licensed electrician.
9.
Plug the line cord into a 220 VAC electrical outlet.
10. Flip the Power Switch on the front of the unit to the ON (I) position. The blower will
start.
SKU 03664
For technical questions, please call 1-800-444-3353.
Cable Strain Relief
Square
Connector "C"
Gas Tube
Outlet "B"
Receptacle "D"
Page 6
Advertisement
Table of Contents
