Searching The Video Tape; Skip Searching The Video Tape; Digital Programme Search System (Dpss) - Sharp VC-M313HM Operation Manual

ADVANCED OPERATION

SEARCHING THE VIDEO TAPE

SKIP SEARCHING THE VIDEO TAPE

You can search the tape in 30 second time intervals. To do this follow the procedure below:
1.
PLAY/X2
Press
2.
SKIP SEARCH
Press
The number of times you press
determines the forward search time.
• After searching, normal playback
will resume automatically

DIGITAL PROGRAMME SEARCH SYSTEM (DPSS)

Your VCR records a marker signal on the tape at the start of each recording. These signals can
be used later to locate the starting point of a recording.
/
Press DPSS
For example,
1.
Load the video tape into the VCR.
2.
Press DPSS
VCR will fast forward to locate the third recording after the current one.
3.
DPSS
Press
to locate the beginning of the current recording.
Rewind
DPSS
Number
4.
To cancel the search before it has finished, press
NOTES:
• Recordings must be longer than 3 minutes.
• The starting point of playback may vary.
• This feature will only work with video tapes recorded on a VCR with the DPSS feature.
If problems persist contact the SHARP Helpline on tel: 0990-274277
( ) to start the video tape playing.
on the remote control.
SKIP SEARCH
to locate a previous programme or the next programme.
three times. The number 3 will appear on the on-screen display, and the
once. A -1 will appear on the on-screen display and the VCR will rewind
DPSS Signals
+1
Current tape position
1 press
2 presses = 1 minute.
3 presses = 1 minute 30 seconds.
4 presses = 2 minutes.
Fast Forward
+2
STOP
(
21
= 30 seconds.
PLAY/X2
) or ( ) .