Program Commands; Delete Commands; Deleting Commands For Only One Mode Key - Tevion 82663 Manual

Program commands

To programme, proceed as follows:
1 Place the remote controls with the infrared diodes facing each other spaced 15 to
50 mm apart on the table. The infrared diodes must be pointing directly at each
other.
SETUP
2 Keep the
SETUP
3 Press briefly three more times to open the
OK
4 Press to open the learn mode.
Confirm once again with OK.
5
6 Now select the mode key on which the device of the original remote control was
programmed.
LEARN KEY
7 The prompt appears. Now select the key on the universal remote
control that is to be assigned to the original remote control function (not:
SETUP or MACRO).
8 In the display you now see
control whose function should be assigned to the universal remote control. Keep
this key pressed until either the
9 The following query appears:
learn functions, confirm with OK. The
as described in point 7.
If you want to end the learn function, press EXIT. The remote control returns to
normal operation.

Delete commands

Deleting commands for only one mode key

Open the learn mode as described in the previous section,
steps 2 to 4. Proceed as follows:
Use the arrows to select  the delete mode and press OK.


Now select the mode key whose commands are to be deleted.

Confirm the additional
If this message does not appear then the mode key does not
have any commands associated with it.
PLEASE WAIT

appears again in the display, followed by the
confirmation message
The remote control returns to normal operation.
Helpline No. UK/ North Ireland 0871 37 61 020 Rep. Ireland 1-800-992 508
Web Support www.medion.co.uk
Model Number: 82663
key pressed for approx. 3 seconds until
LEARNING
. Now select the key on the universal remote
SUCCESS
or
LEARN MORE?
LEARN KEY
prompt by pressing OK.
CONFIRM CLEAR
SUCCESS
.
CODE SETUP
LEARN SETUP
menu.
LEARN ERROR
message appears.
. If you want to perform additional
prompt appears again. Proceed
appears.
20