Table of Contents
Advertisement
The search functions initial "cold start" (when no code is programmed) begins with the most popular brand of
equipment to the least popular. The single LED or current physical Mode LED will illuminate each time a function is
sent (when picked with IR). If the search function is activated after a code has been programmed in, the search
cycle begins with the current programmed ID. Pressing either the CH UP or CH DOWN key, will increment or
decrement to the next table entry and transmit the power (or other) FUNCTION associated with currently selected
table entry and wait for another CH UP or CH DOWN arrow key.
Scanning of the database will be circular. The single LED or current physical Mode LED shall illuminate 3 times
without transmitting IR, once it reaches back to the original ID it will stay in the Library Search mode.
Pressing
<SETUP>
remote control exits library search mode with the current device code. The current physical Mode LED blinks twice
in confirmation. The remote returns to normal operation.
!
If no key is pressed before Ch up/Ch down then default function to be power.
!
Upon entry of an invalid key sequence, the remote control's single LED or current physical Mode LED shall display
one long blink and return to the last preprogrammed code.
!
The unit shall exit programming state and return to the last preprogrammed code, if 10 seconds has elapsed
between digit entries.
!
See the following pages for manufacturer remote codes.
listed at the end of the sequence will store the device code, which was last sampled. The
Advertisement
Table of Contents
