Component Access - KitchenAid KGCT366E Use & Care Manual

Tools Required:
1/4 " Nut Driver
To remove the components for servicing, use the following procedure:
1. Remove the cooktop from the cabinet and turn it over.
2. Remove the hardware (screws and washers) from the burner box cover and lift the
cover off the burner box, then disconnect the three power cord leads (see the inset),
and remove the burner box cover. You can now access all of the components for
service.
Burner Box
Screw (1 of 9)
Installation
Screws
Screw &
Flat Washer
Manifold
Inlet
Tempered Glass Maintop

COMPONENT ACCESS

BURNER BOX
Line 1 (L1)
Power Cord Lead
SPARK
MODULE
COVER
SPARK MODULE
Ground Screw
Green/Yellow
Ground Lead
Neutral (N)
Power Cord Lead
- 3 -
Installation
Screws
Power Cord