Advertisement
Safety instructions
– The washing machine is heavy - take care when lifting it.
– Warning: frozen hoses may tear/burst. Do not install the washing machine outdoors or in
areas where there is a risk of frost.
– The washing machine may be damaged. Do not lift by projecting components (e.g. washing
machine door).
– In addition to the instructions mentioned here, special regulations of the relevant water and
power supply companies may apply.
– If in doubt, have the appliance connected by a technician.
– Lay hoses and cables in such a way that there is no risk that they can be tripped over.
Environmental disposal
– Dispose of packaging in an environmentally friendly manner.
– This appliance has been identified in accordance with the European Directive 2002/96/
EEC on Waste Electrical and Electronic Equipment (WEEE). The Directive specifies a
framework for the return and recycling of waste appliances and is valid throughout Europe.
Scope of delivery
according to model
Aqua-Stop
Aqua-Secure
Covers
Hose holder
Depending on the connection
– A 24-40 mm dia. hose clip may also be required for connecting the siphon (available from
specialist retailers)
page 4: Water connection.
Useful tool
– Spirit level for aligning the washing machine.
Humidity in the drum is
caused by the final inspection.
Standard
Water drainage
Power cord
Water supply
Elbow
for fixing the waste
water hose
Installation area
– Stability is important to prevent the machine from wandering.
– The installation area must be firm and level.
– Soft floors/floor coverings such as e.g. carpets are not suitable.
If installing the appliance on a wooden joist floor
– If possible, install the washing machine in a corner.
– Screw a water-resistant wooden panel (min. 30 mm thick) to the floor.
– It is essential to secure the washing machine feet with holding brackets*.
*order no. WMZ 2200, WX 9756
Hose and cable lengths
Connection on left side
Note
: if hose holders are used, the hose lengths may be reduced.
Available from dealer/customer service:
– Aqua-Stop extension hose**, approx. 2.50 m.
– Longer supply hose, approx. 2.20 m, for standard model.
**order no. WMZ 2380, WZ 10130
Built-under/Built-in appliance
Build-under/build-in before connection to the power supply.
Installed in between kitchen units (built-under or built-in)
– 60 cm cavity width required.
– Install washing machine only under a continuous worktop that is connected firmly to the
adjacent cupboards.
1
depending on model
or
Connection on right side
135 cm
100 cm
~
~
~
95 cm
~
140 cm
160 cm
165 cm
~
~
2
Advertisement
