Panasonic CF-W2 Series Operating Instructions Manual page 29

<When the hard disk backup function has been enabled>
If you select [3] in step 8 (
stallation, the drive name for the second partition (data par-
tition) may be switched with that of the SD Memory Card.
You can still use the drives after the names have been
switched, but you can also return the drive names to their
original state using the following procedures.
(The following procedure assumes that before reinstalla-
tion, the second partition (data partition) was Drive E:, and
the SD Memory Card was Drive D:)
1 Disable the drive name for the second partition (data
partition).
1 In the menu below, select [Computer Management].
Windows XP
Select [start] - [Control Panel] - [Performance and Main-
tenance] - [Administrative Tools].
Windows 2000
Select [Start] - [Settings] - [Control Panel] - [Adminis-
trative Tools].
2 Select [Disk Management].
3 Right click on the partition for which [D:] is displayed
and select [Change Drive Letter and Paths...].
4 Select [Remove].
5 At the confirmation message, select [Yes].
2 Change the SD memory card drive name to [D:].
Use the SD drive name change tool to change the SD
Memory Card to the D: drive. (
Card/ MultiMedia Card").
3 Set the drive name for the second partition (data partition)
as [E:].
1 In the menu below, select [Computer Management].
Windows XP
Select [start] - [Control Panel] - [Performance and Main-
tenance] - [Administrative Tools].
Windows 2000
Select [Start] - [Settings] - [Control Panel] - [Adminis-
trative Tools].
2 Select [Disk Management].
3 Right click on the partition for which the drive name is
not displayed, and select [Change Drive Letter and
Paths...].
4 Select [Add...], assign [E:] as the drive letter, and select
[OK].
page 27) and execute rein-
"SD Memory
29