3, 4, 2, 1
ENTER
Front (L)
SETUP
Exit
SELECT
Test
signal
ENTER RETURN
(L)[A]
A
d
No
B
L
C
FRONT (L) --)CENTER --)FRONT(R)
:
SURROUND (L)(------------ SURROUND(R)
24
RQT5869
OPEN/CLOSE
Í
<
STOP
PAUSE
PLAY
∫
;
1
SKIP
SLOW
/ SEARCH
:
9
6
5
TOP MENU
MENU
ENTER
DISPLAY
RETURN
PLAY MODE SUBTITLE AUDIO ANGLE
REPEAT MODE
1
2
3
A-B REPEAT
4
5
6
Numbered
V.S.S.
buttons
7
8
9
SETUP
CANCEL
0
10
S
Center
Front (R)
[A]
[B] [A] [C]
[A]
L
R
m s
d B
C
0
0
Exit
d B
SW
Test
0
d B
m s
d B
LS
RS
0
0
0
Surround
[B]
(L)[C]
(R)[C]
(R)[A]
LS
LS
e
f
Large
Small
R
C
g
h
SW
i
LS
RS
;
Changing initial settings
Speaker setting
Select either "2-channel" or "Multi-channel" to suit the speakers you
have connected. You can change the following settings when you
select "Multi-channel".
A
Speaker presence and size
1. Press [ , , ,
2. Press [ , ] to select the setting and press [ENTER].
Icon examples: Surround speaker (L)
Large: when the speaker supports low-frequency (under 100 Hz)
reproduction.
Small: Select when the speaker does not support low-frequency
reproduction.
The size setting for the front speakers is automatically determined by
the setting for the subwoofer.
B
Delay time
(Dolby Digital, center and surround speakers only)
For optimum listening with 5.1-channel sound, all the speakers, ex-
cept for the subwoofer, should be the same distance from the seating
position. If you have to place the center or surround speakers closer
to the seating position, adjust the delay time to make up for the differ-
ence.
If distance
speakers) are the same as or greater than
ers), leave the delay time as "0", the factory preset.
If either distance
relevant table and change to the recommended setting.
³Center speaker
Subwoofer
Difference
[C] [A]
Approx. 50 cm
Approx. 100 cm
Approx. 150 cm
Approx. 200 cm
³Surround speakers
Difference
Approx. 200 cm
Approx. 400 cm
Approx. 600 cm
Changing the delay time
1. Press [ , , ,
[ENTER].
2. Press [ , ] to adjust the delay time and press [ENTER].
Channel balance
C
1. Press [ ,
A test signal is output from one speaker at a time, starting with the
front left speaker and proceeding clockwise. ( )
2. While listening to the test signal, press [ ,
volume of the center and surround speakers so they are the
same apparent volume as the front speakers.
(The front speakers cannot be adjusted here.)
3. Press [ENTER].
(The test signals are stopped.)
Note
No signal is output for the subwoofer. To adjust its volume, play
something, then return to this screen to adjust to suit your taste.
When you are finished
Press [ ,
,
] to select the item and press [ENTER].
(from the center speaker) and
(from the front speak-
or
is less than
, find the difference in the
10.6 ms
15.9 ms
] to select the delay time box and press
,
,
] to select "Test" and press [ENTER].
,
] to select "Exit" and press [ENTER].
(from the surround
Setting
1.3 ms
2.6 ms
3.9 ms
5.3 ms
Setting
5.3 ms
] to adjust the