Identifying Controls - Panasonic Viera TX-P42G10E Operating Instructions Manual

Accessories / Options
●
Ensure that the pedestal does not hang over the edge of the base even if the TV swivels to the full rotation range.
●
Do not place any objects or hands within the full rotation range.
●
TX-P42G10E
a: 520 mm / b: 354 mm / c: 15˚
●
TX-P46G10E, TX-P50G10E
a: 528 mm / b: 407 mm / c: 10˚
Rear of the TV
■
Attach the clamper
Insert the clamper
in a hole

Identifying Controls

TV
SD Card slot
(p. 42)
CI slot
(p. 37)
HDMI3 terminal
(p. 55)
PC terminal
(p. 55)
AV3 terminals
(p. 55)
Headphones jack
8
(p. 55)
Adjust the panel to your desired angle
Using the clamper
To remove from the TV:
hole
Keep
pushing both
side snaps
SD CARD
Common
Interface
Mains power On / Off switch
HDMI3
●
Switch On to turn on the TV or
turn the TV to standby mode by
the remote control
PC
AV3
S-V
Remote control
signal receiver
V
●
Do not place any
L
objects between the
TV remote control
R
signal receiver and
remote control.
Set the mark at the centre as illustrated, to
ensure full degree rotation in either direction.
b
c
a
●
Do not bundle the RF cable and mains lead together
(could cause distorted image).
●
Fix cables with clampers as necessary.
●
When using the optional accessory, follow the option's
assembly manual to fix cables.
■
Bundle the cables
snaps
hooks
Recording LED
●
Standby for Direct TV Recording: orange
Power LED
●
Standby: red
On: green
●
When using the remote control, indicates the TV
has received a command.
C.A.T.S. (Contrast Automatic Tracking System) sensor
●
Senses brightness to adjust picture quality when "Eco
Mode" in the Picture Menu is set to "On" (p. 26)
(View from the top)
c
To loosen:
Set the
Keep
knob
tip in the
pushing
hooks
the knob
Function select
●
Volume / Contrast / Brightness /
Colour / Sharpness /
Tint (NTSC mode) / Bass / Treble /
Balance / Auto Setup (p. 30 and p. 31)
Increases or decreases the channel
position by one. When a function is
already displayed, press to increase
or decrease the selected function.
When in Standby mode, switches
TV On.
Changes the input mode