Instructions For Putting Into Use; Components; Assembly - Central Pneumatic 67698 Set Up And Operating Instructions Manual

insTruCTions For PuTTing
inTo use
read the enTire imPorTAnT
sAFeTy inFormATion
section at the beginning of this
manual including all text under
subheadings therein before set up
or use of this product.
From ACCidenTAl
oPerATion:
Turn off and disable the motor
before assembling or making any
adjustments to the compressor
pump.
And deATH From imProPer
insTAllATion:
ONLY a qualified engineer with
appropriate certifications may
attempt designing a new
compressor to ensure that all
required safety and control
elements are in place and will
work together properly and
safely. This compressor pump
is intended only as a
replacement for a similarly
rated pump on an existing
compressor that includes all
other needed components.
Constructing a new compressor
using this pump is not covered
by this manual.
note: For additional information regarding the
parts listed in the following pages, refer
to the Assembly Diagram near the end of
this manual.
Page 8
To PreVenT
serious injury
To PreVenT
serious injury
For technical questions, please call 1-800-444-3353.

Components

Pump Pulley
(58)
Oil Drain Plug (36)
Figure 1

Assembly

Crankshaft (49)
Woodruff Key (50)
Washer (59)
Figure 2
1. Place a small amount of grease in the
slot at the tapered end of the Crankshaft
(49) and insert the Woodruff Key (50)
into the slot.
2. Make sure that the center hole and the
keyway on the Pump Pulley (58) are
clean and free of burrs and rough edges.
Air Filter Assemblies (7)
Oil Fill Plug
(45)
Crankcase
(46)
Oil Sight Glass (38)
Insert Pump Pulley (58)
with this side facing you.
Keyway
Spring Washer (60)
Bolt (61)
SKU 67698