Reduces Power Consumption - Panasonic TH-42LF20E Operating Instructions Manual

Reduces power consumption

• Power management:
• Auto power off:
• Standby save:
• ECO:
1
2
3
When this function is set to On, it operates under the following conditions to turn the
power on or off automatically.
When no pictures are detected for 30 or so seconds during input from PC IN or
DVI-D IN terminal:
→ Power is turned off (standby); the power indicator lights up orange.
When pictures are subsequently detected:
→ Power is turned on; the power indicator lights up green.
Notes:
• This function operates only during input from PC IN or DVI-D IN terminal.
• This function is effective when "Sync" is set to "Auto" and during normal viewing (one
picture screen).
Equipment power supply is turned Off when there is no signal.
When this is set to On, the power supply of the unit goes Off 10 minutes after the
input signals stop.
Note:
This function is effective during normal viewing (one picture screen).
When this function is set to "On", serial communication is disabled during standby
mode, reducing the power consumption during standby.
To perform serial communication while in standby, set this function to "Off(SERIAL)".
However, the standby power consumption is greater than when it is set to "On".
This function adjusts the brightness of the backlight to reduce power consumption.
Off: This function does not operate.
On: Backlight brightness is reduced.
Sensor: The backlight brightness is automatically adjusted according to the viewing
environment.
Note:
When this function is set to "On" or "Sensor", the "Backlight" setting in the Picture
menu is disabled.
Press to select the menu to adjust.
Press to select "On" or "Off".
On Off
Press to exit from Setup.
Setup 1/2
Signal
Screensaver
Input label
Off
Wobbling
Component/RGB-in select
RGB
Power management
Off
Auto power off Off
Off ( SERIAL )
Standby save
ECO
Off
English ( UK )
OSD Language
31