Recommended Oil Type; Recommended Fuel Type; Oil And Fuel Recommendations; Oil And Fuel Mixing Instructions - MTD T/120 User Manual

NOTE: This unit is shipped without gasoline or oil. In
order to avoid damage to the unit, refer to Oil
and Fuel Information to put oil and gas in the
crankcase before attempting to start it.
NOTE: Before setting up your cultivator, disconnect the
spark plug wire from the spark plug.
Positioning the Handlebars
1. Loosen the two knobs on the inside of the
handlebars (Fig. 1).
2. With the unit upright, swing the handlebars up into
the operating position (Fig. 1).
NOTE: Take care not to pinch the throttle cable or
switch wires when positioning the handlebar.
3. Tighten the knobs to secure the handlebars in place.
NOTE: Do not over-tighten the knobs.

RECOMMENDED OIL TYPE

Use high quality oil formulated for use in 2-cycle, air-
cooled engines. Mix the oil according to the instructions
on the 2-cycle engine oil container, 40:1 (2.5 %).

RECOMMENDED FUEL TYPE

Always use clean, fresh, unleaded petrol (gasoline).
14

ASSEMBLY INSTRUCTIONS

OIL AND FUEL RECOMMENDATIONS

Adjusting Tine Depth
Tine adjustment will vary depending on the type of soil
being cultivated and how it will be used. Generally,
adjusting the tines to break the soil 4 to 6 inches is
recommended for most gardens.
Adjust the tines as follows:
1. Stop the engine and disconnect the spark plug wire.
2. Loosen (do not remove) the two wing nuts (5) on the
tine guard (4) (Fig. 3).
3. Slide the wheel down for shallower and up for
deeper tine penetration.
4. Once the tines are in the desired position, tighten the
wing nuts, making sure that the carriage bolts are
seated properly through the bracket (Fig. 4).
5. If the tine depth is not correct, repeat steps 2 to 4.
6. Reconnect the spark plug wire and continue use.

OIL AND FUEL MIXING INSTRUCTIONS

Old and/or improperly mixed fuel are the main reasons
for the unit not running properly. Be sure to use fresh,
clean unleaded fuel. Follow the instructions carefully for
the proper fuel/oil mixture.
Thoroughly mix the proper ratio of 2-cycle engine oil
with unleaded petrol, 40:1 (2.5 %). Do not mix them
directly in the tank.